3. Set the port mapping in the virtual severs of Forwarding. By default, camera uses
port 80, 8000, 554 and 8200. You can change these ports value with web browser or
client software.
Example:
When the cameras are connected to the same router, you can configure the ports of
a camera as 80, 8000, 554 and 8200 with IP address 192.168.1.23, and the ports of
another camera as 81, 8001, 555, 8201 with IP 192.168.1.24. Refer to the steps as
below:
STEPS
1. As the settings mentioned above, map the port 80, 8000, 554 and 8200 for the
network camera at 192.168.1.23
2. Map the port 81, 8001, 555 and 8201 for the network camera at 192.168.1.24.
3. Enable ALL or TCP protocols.
4. Check the Enable checkbox and click.
Figure A.2.3 - Port Mapping
Note:
The port of the network camera cannot conflict with other ports. For example, some
web management port of the router is 80. Change the camera port if it is the same as
the management port.
