ENGLISH
37
Setting the clock
To set the clock, switch the ignition off and select the SPEED/CLK mode.
Press and hold the MODE button for 3 seconds. The blinking digits can be
changed using the + and – buttons. Press the MODE button to move to the
next digit.
If no button is pressed for 20 seconds, the settings will be stored automati-
cally and the display will return to the SPEED/CLK mode.
+
BUTTON time +
–
BUTTON time –
press the MODE
BUTTON to change to the next digit
press and hold the MODE
BUTTON 3 SECONDS to store the time and return to
the SPEED/CLK mode
Activating/deactivating the display modes
It may not be necessary to display all of the display modes (functions) at the
same time. It is possible to conceal any information not currently required.
By deactivating certain functions, the MODE button will only allow you to
select from the activated modes.
In the SPEED/H mode, press and hold the MODE button for 3 seconds to
access the SETUP menu. The blinking function can be activated by pressing
the + button and deactivated by pressing the – button.
If no button is pressed for 20 seconds, the setting will be stored automati-
cally and the display will return to the SPEED/H mode.
+
BUTTON activates the blinking display
–
BUTTON deactivates the blinking display
press the MODE BUTTON to change to the next display without changing
any settings
press and hold the MODE
BUTTON 3 SECONDS to store the settings and
change to the SPEED/H mode
Kilometers or miles
The unit (kilometers or miles) can also be changed. The ODO figure will be
retained and converted accordingly. The TRP1, AVS1, STP1, TRP2 and
AVS2 figures will be cleared.
To select the unit, select the SPEED/H mode and hold the MODE button for
3 seconds to access the SETUP menu. Press the MODE button 10 times
until the KMH/MPH function blinks. Press the + button to move to the
options. Press the + button for KMH or the – button for MPH. If no button
is pressed for 20 seconds, the setting will be stored automatically and the
display will return to the SPEED/H mode.
The setting can be stored immediately by holding the MODE button for a
few seconds until the display returns to the SPEED/H mode.
+
BUTTON to access the menu
to activate the KMH setting
–
BUTTON to activate the MPH setting
press the MODE
BUTTON to change to the next mode
press and hold the MODE
BUTTON 3 SECONDS to store the setting and return
to the SETUP menu
NOTE:
If you retrofit this Tripmaster on another motorcycle, the power can also be
supplied by the 12 V vehicle electric system. You will need an additional
cable harness, spare part no. 583.14.069.210, which you can order from
your KTM dealer.
