583360
72
Zoom out
Zoom in
Vorherige Seite
1/153
Nächste Seite
7-5C
Static ignition values 250-380 SX, EXC (except 250 USA)
Check the pulse generator for an output signal – two-pin connector 1
with green and red cable colors (also see circuit diagram on opposite
page):
Apply the red measuring lead of the peak voltage adapter to the green
cable and the black measuring lead to the red cable, disconnect both
connectors
1 to disconnect the CDI unit 2
Multimeter display: 6 volts +/- 1 volt
(250 SX model 2000/2001: 5 volts +/- 1 volt)
Same measurement with CDI unit connected
Multimeter display: 3 volts +/- 1 volt
(250 SX model 2000/2001: 9 volts +/- 1 volt)
Check the generator charging coil for ignition capacitor charge for out-
put voltage – two-pin connector
3 with black/red and red/white cable
colors (also see circuit diagram on opposite page):
Apply the red measuring lead of the peak voltage adapter to the
black/red cable and the black measuring lead to the red/white cable,
disconnect connector
3 to disconnect the CDI unit 2
Multimeter display: 35 volts +/- 5 volts
Same measurement with connectors CDI unit connected
Multimeter display: 200 volts +/- 10 volts
Check the primary voltage output
4 for ignition coil control (also see cir-
cuit diagram on opposite page) for output voltage (blue/white cable
color):
Apply the red measuring lead
R of the peak voltage adapter to the
black/white cable (ground) and the black measuring lead
S to the
blue/white cable, CDI unit
2 and ignition coil 5 connected
Multimeter display: 200 volts +/- 10 volts
NOTE: the ignition coil does not need to be removed to measure.
STATIC IGNITION VALUES 250-380 SX, EXC (KOKUSAN 2K-1, 2K-3, 2K-4)
Measuring conditions:
cold engine
seat and tank removed
all connectors and the ground connection in a non-corroding condition, connectors tightly connected
spark plug screwed out and spark plug connector attached to ground
light switch turned off
the gap between the rotor and pulse generator must be set to 0.75 mm
kick the kick starter forcefully at least 5 times for each measurement
3
1
1
5
4
S
R
72

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für KTM 380 SX wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info