Bedienungsanleitung Kubota BX25DLB (Seite 15 von 143) (Englisch)

639486

Zoom out

Zoom in

Vorherige Seite

1/143

Nächste Seite

-5SAFE OPERATION

Before servicing the tractor, park it on a firm, flat and level

surface, set the parking brake, lower all implements to the

ground, place the gear shift lever in neutral, stop the

engine and remove the key.

1. Allow the tractor time to cool off before working on or

near the engine, muffler, radiator, etc.

2. Do not remove radiator cap while coolant is hot. When

cool, slowly rotate cap to the first stop and allow

sufficient time for excess pressure to escape before

removing the cap completely. If the tractor has a

coolant recovery tank, add coolant or water to the tank,

not the radiator. (See "Checking Coolant Level" in

"DAILY CHECK" in "PERIODIC SERVICE OF THE

TRACTOR" section.)

3. Always stop the engine before refueling. Avoid spills

and overfilling.

4. Do not smoke when working around battery or when

refueling. Keep all sparks and flames away from

battery and fuel tank. The battery presents an

explosive hazard, because it gives off hydrogen and

oxygen especially when recharging.

5. Before "jump starting" a dead battery, read and follow

all of the instructions. (See "JUMP STARTING" in

"OPERATING THE ENGINE" section.)

6. Keep first aid kit and fire extinguisher handy at all

times.

7. Disconnect the battery's ground cable before working

on or near electric components.

8. To avoid the possibility of battery explosion, do not use

or charge the refillable type battery if the fluid level is

below the LOWER ( lower limit level ) mark. Check the

fluid level regularly and add distilled water as required

so that the fluid level is between the UPPER and

LOWER levels.

9. To avoid sparks from an accidental short circuit,

always disconnect the battery's ground cable (-) first

and reconnect it last.

10.Do not attempt to mount a tire on a rim. This should be

done by a qualified person with the proper equipment.

11.Always maintain the correct tire pressure. Do not

inflate tires above the recommended pressure shown

in the operator's manual.

12.Securely support the tractor when either changing

wheels or adjusting the wheel tread width.

13.Make sure that wheel bolts have been tightened to the

specified torque.

14.Do not work under any hydraulically supported

devices. They can settle, suddenly leak down, or be

accidentally lowered. If it is necessary to work under

tractor or any machine elements for servicing or

adjustment, securely support them with stands or

suitable blocking beforehand.

15.Escaping hydraulic fluid under pressure has sufficient

force to penetrate skin, causing serious personal

injury. Before disconnecting hydraulic lines, be sure to

release all residual pressure. Before applying

pressure to the hydraulic system, make sure that all

connections are tight and that all lines, pipes, and

hoses are free of damage.

6. SERVICING THE TRACTOR

(1) Battery

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Kubota BX25DLB Seite 15

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info