Bedienungsanleitung Kuppersbusch ikd 3700 0 e (Seite 5 von 9) (Deutsch)

131011

Zoom out

Zoom in

Vorherige Seite

1/9

Nächste Seite

in den normalen Hausmüll gehört, sondern den jeweiligen kommunalen Rücknahmesystemen für Elektro- und

Elektronik-Altgeräte übergeben werden muss. Die Entsorgung muss im Einklang mit den geltenden Umweltrichtlinien

für die Abfallentsorgung erfolgen. Für nähere Informationen über Entsorgung und Recycling dieses Produktes

wenden Sie sich bitte an Ihre kommunalen Einrichtungen (Umweltamt) oder an die Abfallentsorgungsgesellschaft

Ihrer Stadt bzw. an Ihren Händler.

ENGLISH

WARNING

The distance between the supporting surface for the cooking vessels on the hob and the lower part of the hood must

be at least 65 cm. If the instructions for installation for the hob specify a greater distance, this has to be taken into

account.

The air collected must not be conveyed into a duct used to blow off smokes from appliances fed with an energy other

than electricity (central heating systems, thermosiphons, water-heaters, etc.).

Comply with the official instructions provided by the competent authorities in merit when installing the disposal duct.

In addition, exhaust air should not be discharged into a wall cavity, unless the cavity is designed for that purpose.

The room must be well aerated in case a hood and some other heat equipment fed with an energy other than electricity

(gas, oil, coal heaters, etc) operate at the same time.

In fact the intake hood, disposing of air, could create a vacuum in the room. The vacuum should not exceed 0,04mbar.

This prevents the gas exhausted by the heat source from being intaken again. It is therefore advisable to ensure

the room contains air taps able to ensure a steady flow of fresh air.

Check the data label inside the appliance; if the symbol ( ) is printed, read the following: this appliance has

such technical particulars that it belongs to class II insulation, therefore it must not be earthed.

The following warning is valid in the United Kingdom only: in case your cable is not furnished with a plug, read the

following instructions; as the colours of the wires in the mains lead of this appliance may not correspond with the

coloured markings identifying the terminals in your plug, proceed as follows: – the wire which is coloured blue must

be connected to the terminal which is marked with the letter N or coloured black; – the wire which is coloured brown

must be connected to the terminal which is marked with the letter L or coloured red. – terminal of a three-pin plug.

Check the data label inside the appliance; if the symbol ( ) is NOT printed, read the following: ATTENTION:

This appliance must be earthed. When making the electrical connections, check that the current socket has a ground

connection.

The following warning is valid in the United Kingdom only: in case your cable is not furnished with a plug, read the

following instructions; as the colours of the wires in the mains lead of this appliance may not correspond with the

coloured markings identifying the terminals in your plug, proceed as follows:

– the wire which is coloured green and yellow must be connected to the terminal in the plug which is marked with the

letter E or by the earth symbol [

], or coloured green or green and yellow; – the wire which is coloured blue must

be connected to the terminal which is marked with the letter N or coloured black; – the wire which is coloured brown

must be connected to the terminal which is marked with the letter L or coloured red.

When making the electrical connections, check that the voltage values correspond to those indicated on the data

plate inside the appliance itself. In case your appliance is not furnished with a non separating flexible cable and has

no plug, or has not got any other device ensuring omnipolar disconnection from the electricity main, with a contact

opening distance of at least 3 mm, such separating device ensuring disconnection from the main must be included

in the fixed installation. If your unit features a power lead and plug, position this so the plug is accessible.

Always switch off the electricity supply before carrying out any cleaning or servicing operations on the appliance.

USE

Avoid using materials which could cause spurts of flame (flambées) near the appliance.

When frying, take particular care to prevent oil and grease from catching fire. Already used oil is especially dangerous

in this respect. Do not use uncovered electric grates.

To avoid possible risks of fire always comply with the indicated instructions when cleaning anti-grease filters and

when removing grease deposits from the appliance.

MAINTENANCE

Thorough servicing guarantees correct and long-lasting operation.

Any fat deposits should be removed from the appliance periodically depending on amount of use (at least every 2

months). Avoid using abrasive or corrosive products. To clean painted appliances on the outside, use a cloth dipped

in lukewarm water and neutral detergent. To clean steel, copper or brass appliances on the outside, it is always best

to use specific products, following the instructions on the products themselves. To clean the inside of the appliance,

use a cloth (or brush) dipped in denatured ethyl alcohol.

Kuppersbusch ikd 3700 0 e Seite 5

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Kuppersbusch ikd 3700 0 e

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info