522406
22
Zoom out
Zoom in
Vorherige Seite
1/29
Nächste Seite
Appendix
23
Route and Secure the Cables
1. Remove the four M4 screws securing the
cable brackets to the inside rim of the
baseplate (see Figure 44). Remove and save
the cable brackets.
2. Route the data/power (F-type connector end)
(see Figure 45) and RF cables belowdecks
through the cable access hole. Leave an
adequate service loop, approximately 8"
(20 cm) of slack, in the cables for easy
serviceability. Later, you will connect the
data/power cable to the MCU and the RF
cable(s) to the receiver(s).
3. Route the N-type connector end of the data/
power cable (see Figure 45) through the
baseplate’s bottom cable access hole. Connect
the data/power cable to the center connector
on the cable PCB (see Figure 46).
4. Route the RF cable(s) through the baseplate’s
bottom cable access hole. Using a 9/16"
wrench, connect the RF cable(s) to the cable
PCB (see Figure 46). If you need to connect
only one RF cable, connect the cable to the
RF1 connector. Connect any additional RF
cables to the RF2, RF3, and RF4 connectors.
See Figure 9 on page 6 to determine the
number of RF cables required.
TIP: If you connect two or more RF cables, label both
ends of each cable to match the connector. This will
make it easier to identify the cables later.
Be sure to properly align the data/power
cable with the PCB connector before
tightening. Connecting the cable at an angle
may damage the cable’s center tines.
IMPORTANT!
Continued Bottom Cable Entry Kit
A
Figure 44 Cable Brackets on Inside Rim of Baseplate
Figure 45 Data/Power Cable Connections
Figure 46 Cable Connections on PCB
M4 Screw (x4)
F-type Connector N-type Connector
MCU Antenna
Data/
Power
RF1 RF3RF4 RF2
22

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für KVH TracVision M9 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Andere Handbücher von KVH TracVision M9

KVH TracVision M9 Bedienungsanleitung - Englisch - 73 seiten


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info