Bedienungsanleitung Kyocera FS5800C (Seite 3 von 131) (Englisch)

20371

Zoom out

Zoom in

Vorherige Seite

1/131

Nächste Seite

2. Copy Restrictions

FONTWARE/TrueDoc is copyrighted. Unauthorized copying of FONTWARE/TrueDoc even if modified, merged, or

included with other software, is expressly forbidden. You may be held legally responsible for any copyright in-

fringement.

3. Unauthorized Use

FONTWARE/TrueDoc may not be removed, disclosed and transferred to any third party for any length of time

without the prior written consent of KYOCERA or BITSTREAM. Also, you may not modify, adapt, translate, reverse

engineer, decompile, or create derivative works based on FONTWARE/TrueDoc.

4. Term

This agreement should remain in full force and effect forever thereby allowing the Sublicensee to use the

FONTWARE/TrueDoc forever unless the Sublicensee violates the terms of paragraphs 2. or 3. above. In the event of

such violation, this agreement will terminate automatically without notice from KYOCERA. Upon termination, you

should destroy FONTWARE/TrueDoc and all copies of them, in part and in whole, including modified copies, if any.

Important note on the interface connectors

Be sure to turn off printer power before connecting or disconnecting an interface cable* to the printer. For protection

against static discharge which may be applied to the printer’s internal electronics through the interface

connector(s), keep any interface connector which is not in use capped using the protective cap supplied.

* A shielded interface cable must be used.

Safety information

Laser safety

This printer is certified as a Class 1 laser product under the U.S. Department of Health and Human Services

(DHHS) Radiation Performance Standard according to Radiation Control for Health and Safety Act of 1968. This

means that the printer does not produce hazardous laser radiation. Since radiation emitted inside the printer is

completely confined within protective housings and external covers, the laser beam cannot escape from the printer

during any phase of user operation.

Laser notice

This printer is certified in the U.S. to conform to the requirements of DHHS 21 CFR Subchapter for Class I (1) laser

products, and elsewhere is certified as a Class I laser product conforming to the requirements of IEC 825.

CAUTION Invisible laser radiation when open. AVOID DIRECT EXPOSURE TO BEAM.

Use of controls or adjustments or performance of procedures other than those specified herein may result in

hazardous radiation exposure.

CDRH regulations

The Center of Devices and Radiological Health (CDRH) of the U.S. Food and Drug Administration implemented

regulations for laser products on August 2, 1976. These regulations apply to laser products manufactured after

August 1, 1976. Compliance is mandatory for products marketed in the United States. A label indicating compliance

with the CDRH regulations must be attached to laser products marketed in the United States.

Ozone concentration

The printer generates ozone gas (O3) which may concentrate in the place of installation and cause an unpleasant

smell. To minimize concentration of ozone gas to less than 0.1 ppm, we recommend you not to install the printer in a

confined area where ventilation is blocked.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Kyocera FS5800C Seite 3

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info