435980
58
Zoom out
Zoom in
Vorherige Seite
1/76
Nächste Seite
Section 7 TROUBLESHOOTING
7-2
“E72” appears on the copy quantity/
magnification display
Originals for another job were set in the optional Document Processor
during copying from the platen in the 2-in-1 or 4-in-1 layout mode or in
the Sort mode.
Remove the new originals from the Document Processor and, once the
copy operation for the 2-in-1 or 4-in-1 layout mode or the Sort mode is
completed, reset them on the original table and try to copy again.
“E90” appears on the copy quantity/
magnification display
The copier’s memory is full.
To copy from those originals already scanned:
Press the Recall%/Enter key and copying will begin. Once those copies
have been made, reset the originals that have not yet been copied and
press the Start key. Copying will continue.
To start the copy procedure once again from the beginning:
Press the Stop/Clear key, set a lesser number of originals and try to copy
again.
“OP” appears on the copy quantity/
magnification display
The upper front cover or the front cover to the copier is open.
Close the covers securely.
“OP1” appears on the copy quantity/
magnification display
The left cover to the Document Processor is open.
Close the cover securely.
“J” and a number appear on the copy
quantity/magnification display
A paper jam has occurred.
Refer to “If paper jams” on page 7-3 and remove the jammed paper.
7-3
The Add Toner indicator lights The toner supply has run low.
Copying will still be available for awhile, but will then become impossible.
Replace the toner container as soon as possible.
8-2
The Add Toner indicator lights and “E33”
appears on the copy quantity/magnification
display
Toner has run out so further copying is impossible.
Replace the toner container.
8-2
“C” and a number appear on the copy
quantity/magnification display
Turn the power switch OFF ({) and then back ON ( | ) again. If the error
indication does not go out, make a note of the “C” and the number. Turn
the power switch OFF ({), remove the power cord, and contact your
service representative or an authorized service center.
“A” and a number appear on the copy
quantity/magnification display
Turn the power switch OFF ({) and then back ON ( | ) again. If the error
indication does not go out, make a note of the “A” and the number. Turn
the power switch OFF ({), remove the power cord, and contact your
service representative or an authorized service center.
Indication Procedure
Reference
Page
58

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Kyocera km 1500 laser 15ppm wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info