495637
127
Zoom out
Zoom in
Vorherige Seite
1/150
Nächste Seite
Troubleshooting
OPERATION GUIDE 9-7
The waste toner box is full. Replace it with a new waste
toner box.
8-5
250 copies have been stored on output tray. Remove
the paper, press [Start] and resume copying.
Originals were set in the optional Document Processor
when copying on 2-sides (front and back sides), when
copying from the platen in 2-Sided copy, 2 in 1, 4 in 1 or
when collating copies. Remove the originals from the
Document Processor, replace the originals on the
Original Table after exiting the front and back copying, 2-
Sided copy, 2 in 1, 4 in 1 or Collate Mode and resume
copying.
If the optional Document Processor is being used, there
are originals left on the original table. Remove the
originals, return them to the original table and try
copying them again.
Check the paper cassette that corresponds to the
lighting indicator. Set the cassette.
2-2
The Toner Container has not been set. Set the Toner
Container.
8-5
The Add Toner indicator blinks on
and off.
There is very little toner remaining. Copying can be
continued for a short while before running out of toner.
Replace the toner container with a new one as soon as
possible.
8-5
The Periodic Maintenance
indicator blinks on and off.
This is a notification that the time for periodic
maintenance is approaching.
The Periodic Maintenance
indicator lights up.
It is time for Periodic Maintenance. Contact your service
representative.
“= = =” appears on the copy
quantity display.
Job Accounting being set. Use the numeric keys to enter
the assigned Section Code to perform copying
operations. Press [Job Accounting] after copying is
finished to display “= = =” again.
6-6
“-” appears on the copy quantity
display.
The copier is in the Sleep Mode setting. Press [Energy
saver] to exit the mode.
3-9
Display Corrective Procedure
Reference
Page
Replace waste
toner box.
Remove paper on
top tray; Start.
Reseat originals
on DP.
Return all
originals to DP.
Set paper
cassette.
Set toner
container.
127

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Kyocera KM1635 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info