Bedienungsanleitung La Nordica Fly (Seite 16 von 60) (Deutsch, Englisch, Französisch, Italienisch)

811733

Zoom out

Zoom in

Vorherige Seite

1/60

Nächste Seite

4. FIRE SAFETY

When installing the product, the following safety measures must be observed:

a) In order to ensure sufcient thermal insulation, respect the minimum safety distance from objects or furnishing components ammable

and sensitive to heat (furniture, wood sheathings, fabrics. etc.) and from materials with ammable structure (see Picture 4 at page 41 -

A). All the minimum safety distances are shown on the product data plate and lower values must not be used.

b) In front of the furnace door, in the radiation area there must be no ammable or heat-sensitive objects or material at a distance of less

than 100 cm. This distance can be reduced to 40 cm where a rear-ventilated, heat-resistant protection device is installed in front of the

whole component to protect.

c) If the product is installed on a non totally refractory oor, one must foresee a reproof background. The oors made of inammable

material, such as moquette, parquet or cork etc., must be replaced by a layer of no-inammable material, for instance ceramic, stone,

glass or steel etc. (size according to regional law). The base must extend at least 50 cm at the front and at least 30 cm at the sides, in

addition to the opening of the loading door (see Picture 4 at page 41 - B).

d) No ammable components (e.g. wall units) must be present above the product.

The Product must always operate exclusively with the ash drawer inserted. The solid combustion residues (ash) must be collected in a

sealed, re resistant container. The Product must never be on in the presence of gaseous emissions or vapours (for example glue for

linoleum, petrol etc.). Never deposit ammable materials near the Product.

During combustion, thermal energy is released which leads to considerable heating of the surfaces, doors, handles, controls, glass parts,

the ue gas pipe and possibly the front part of the appliance. Avoid contact with these elements unless using suitable protective

clothing or accessories (heat resistant gloves, control devices).

Ensure children are aware of these dangers and keep them away from the furnace when it is on.

When using the wrong fuel or one which is too damp, due to deposits present in the ue, a ue re is possible.

4.1. IN A EMERGENCY

If there is a re in the ue connection :

a) Close the loading door and the ash drawer door

b) Close the comburent air registers

c) Use carbon dioxide ( CO2 powder ) extinguishers to put out the re

d) Request the immediate intervention of the Fire Brigade

DO NOT PUT OUT THE FIRE WITH WATER.

When the ue stops burning, have it checked by a specialist to identify any cracks or permeable points.

FLY SOSPESO - FLY CON SUPPORTO - FLY CON CASSETTONE

16 7193500 - IT - EN - DE - FR

• Make sure that the oor can support the weight of the appliance (for ex. distributing weight plate), and if it is made of ammable

material, provide suitable insulation (DIMENSIONS ACCORDING TO REGIONAL REGULATIONS).

• Make sure that there is adequate ventilation in the room where the appliance is to be installed, with particular attention to windows

and doors with tight closing (seal ropes).

• Do not install the appliance in rooms containing collective ventilation ducts, hoods with or without extractor, type B gas appliances,

heat pumps, or other appliances that, operating at the same time, can put the room in depression (ref. UNI 10683 standard).

• Make sure that the ue and the pipes to which the appliance will be connected are suitable for its operation. It is NOT allowed the

connection of various appliances to the same chimney.

• The diameter of the opening for connection to the chimney must at least correspond to the diameter of the ue gas pipe. The

opening must be equipped with a wall connection for the insertion of the exhaust pipe and a rosette.

• The installation must be appropriate and has to allow the cleaning and maintenance of the product and the ue.

La NORDICA S.p.A. declines all responsibility for damage to things and/or persons caused by the system. In addition, it is not

responsible for any product modied without authorisation and even less for the use of non original spare parts.

Your regular local chimney sweep must be informed about the installation of the appliance so that he can check the correct connection to

the chimney.

5. TECHNICAL DESCRIPTION

The chimney stoves of La Nordica are suitable to heat living spaces for some periods. As fuel, wood logs are used. The appliance works

as an intermittent operating appliance.

The appliance is made up of a steel chamber completely soldered and hermetic. The hearth is coated by single castiron sheets and

refractory plates (IRONKER). Inside the hearth there are a grate holder and the related grating, both made of very thick cast-

iron and easily extractable. The inside smoke plate, reects the re radiation and increases the internal temperature of the combustion

chamber. This process together with the exhaust gases ows, makes optimal the combustion and improves the efciency.

The appliance is equipped with a sight door with ceramic glass (resistant up to 700°C). This allows a charming sight on

burning ames. Moreover, in this way, any possible leak of sparks and smoke is avoided. Under the hearth grating there is a

easily extractable ash drawer Picture 6 at page 42.

The heating of the room occurs:

a) by radiation: through the panoramic glass and the external hot surfaces of the stove, the heat is radiated into the environment.

La Nordica Fly Seite 16

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info