Bedienungsanleitung La Nordica INSERTO 80 HIGH PRESSURE (Seite 27 von 108) (Deutsch, Englisch, Französisch, Italienisch, Spanisch)

811754

Zoom out

Zoom in

Vorherige Seite

1/108

Nächste Seite

ENGLISH

TECHNICAL DESCRIPTION

The appliance is made up of a steel chamber completely soldered and hermetic. The hearth is coated by single cast-iron sheets and refractory

plates (NORDIKER).The appliances are equipped with an integrated air circuit for the recovery of the heat made up of a galvanized

steel carter external to the heating body. Inside the hearth there are a grate holder and the related grating, both made of very

thick cast-iron and easily extractable. The appliance works as an intermittent operating appliance.

The insert is equipped with a sight door with ceramic glass (resistant up to 700°C). This allows a charming sight on burning ames. Moreover,

in this way, any possible leak of sparks and smoke is avoided. Under the hearth grating there is a easily extractable ash drawer, also when the

appliance works.

ACCESSORIES POKER GLOVE VENTILATION

SERIES SERIES SERIES

The heating of the room occurs:

a) by convection: the passage of air through the coating and the covering hood releases heat in the room.

b) by radiation: through the sight glass and the steel body, heat is radiated into the room.

c) by forced convection: a ventilation kit suitable to improve the distribution of heat by ventilation only either of the installation room or

of the adjacent local.

The device is equipped with registers of primary and secondary air, with which it is possible to adjust the combustion air.

1A - PRIMARY air register (Picture 8)

With the air register located under the door of the hearth (on the left), it is possible to adjust the air ow through the ash drawer and the

grating in direction of the fuel. The primary air is necessary for the combustion process during the ignition. In order to open the passage of

primary air the lever should be completely pulled.

The ash drawer has to be emptied regularly, so that ash cannot hinder the intake of primary air for the combustion. Primary air is also

necessary to keep re live.

During the combustion of wood, the primary air register must be opened only a few, since otherwise the wood burns quickly and the

device can overheat (see chapter NORMAL OPERATION).

2A - SECONDARY air register (Picture 8)

Under the door of the hearth (on the right) there is the secondary air register.

This register must be opened (and therefore the lever completely pushed), in detail, for the combustion of wood, so that unburnt carbon

can be subject to a post-combustion, increasing the yield and assuring the cleaning of the glass (see chapter NORMAL OPERATION). It is

possible to get the air SECONDARY directly from outside through a exible tube (reproof NOT furnished Picture 11 Ref A).

The adjustment of the registers necessary to reach the rated caloric yield is the following one:

Hourly consumption in kg/h PRIMARY air SECONDARY air TERTIARY AIR

2,3 CLOSED Picture 8 1/4 OPEN PRE - ADJUSTED

C - FAN ELECTRIC THERMOCONTROLLER (Picture 14 - Picture 15).

UNIT OPERATION.

This electronic thermocontroller for packaged units manages ventilation air ows.

The unit is switched on or o by pressing and holding the 1 button. During operation

the display shows the set speed alternating with unit status, led 9.

When the unit is o, the display also remains o.

The unit can be controlled MANUALLY or AUTOMATICALLY.

MANUAL mode

To access MANUAL mode, press the 2 button; when the 3 light comes on the function

is active. The 4-5 buttons are used to select one of the ve fan speeds, also active

when the ue is cold.

The motor is started in automatic mode by a mechanical thermostat (the display

shows WAIT), which is activated when the temperature is at least 45°C (xed value,

not modiable). The 6 led indicates that the thermostat contact is closed.

AUTOMATIC mode

To access AUTOMATIC mode, press the 2 button; when the 7 light comes on the function is active. Use the 5 button to set the speed. The 4-5

buttons are used to select one of the ve fan speeds.

In automatic mode the COMFORT temperature can also be selected. Press the 4 button to access the COMFORT temperature setting and

then set the value using 4-5. This setting allows the user to reduce fan noise when the room temperature measured by the probe inside

the controller exceeds the comfort set point; the motor operates one speed lower (this mode has no eect in rst speed) and is signalled

by the 8 led.

LANGUAGE menu.

Pressing and holding the 2 button accesses the LANGUAGE menu, where the display language can be changed using the 4-5 buttons (IT,

EN, DE, FR). Pressing the 2 button briey again accesses the DISPLAY menu, where the brightness can be adjusted (between 10 and 150).

Pressing the 2 button briey another time accesses the DEGREES menu, where the temperature display can be set as °C or °F.

BUZZER menu

Pressing the 2 button briey a nal time accesses the buzzer menu, where audible buzzer can be enabled or disabled.

AOK

1 2 3 4

3 7 89

4 5

2727

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

La Nordica INSERTO 80 HIGH PRESSURE Seite 27

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info