Bedienungsanleitung La Nordica Inserto Crystal 50V P30 (Seite 23 von 96) (Deutsch, Englisch, Französisch, Italienisch, Spanisch)

696288

Zoom out

Zoom in

Vorherige Seite

1/96

Nächste Seite

ENGLISH

TECHNICAL DESCRIPTION

The appliance is made up of a steel chamber completely soldered and hermetic. The hearth is coated by single cast-iron sheets and refractory

plates (NORDIKER).The appliances are equipped with an integrated air circuit for the recovery of the heat made up of a galvanized steel carter

external to the heating body. Inside the hearth there are a grate holder and the related grating, both made of very thick cast-iron and easily

extractable. The appliance works as an intermittent operating appliance.

The insert is equipped with a sight door with ceramic glass (resistant up to 700°C). This allows a charming sight on burning ames. Moreover,

in this way, any possible leak of sparks and smoke is avoided. Under the hearth grating there is a easily extractable ash drawer.

ACCESSORIES

POKER GLOVE

Ventilation KIT 1318000

SECONDARY air KIT

INSERTO 50 Crystal SERIES SERIES / 6016040 OPTIONAL

INSERTO 50V Crystal BII SERIES SERIES / 6016040 OPTIONAL

INSERTO 50V p30 Crystal SERIES SERIES / 6016040 SERIES

INSERTO 70 Crystal SERIES SERIES * OPTIONAL 6016041 OPTIONAL

INSERTO 80 Crystal EVO 2.0 SERIES SERIES * OPTIONAL 6016041 OPTIONAL

INSERTO 80 Crystal PRS SERIES SERIES * OPTIONAL 6016041 OPTIONAL

INSERTO 100 Crystal SERIES SERIES * OPTIONAL 6016041 OPTIONAL

* see instructions manual CONNECTION AND MAINTENANCE OF VENTILATION OPTIONAL.

The heating of the room occurs:

a) by convection: the passage of air through the coating and the covering hood releases heat in the room.

b) by radiation: through the sight glass and the steel body, heat is radiated into the room.

The device is equipped with registers of primary and secondary air, with which it is possible to adjust the combustion air.

1A - PRIMARY air register (Picture 8)

With the air register located under the door of the hearth (on the left), it is possible to adjust the air ow through the ash drawer and the

grating in direction of the fuel. The primary air is necessary for the combustion process during the ignition. In order to open the passage of

primary air the lever should be completely pulled.

The ash drawer has to be emptied regularly, so that ash cannot hinder the intake of primary air for the combustion. Primary air is also

necessary to keep re live.

During the combustion of wood, the primary air register must be opened only a few, since otherwise the wood burns quickly and the

device can overheat (see chapter NORMAL OPERATION).

2A - SECONDARY air register (Picture 83)

Under the door of the hearth (on the right) there is the secondary air register.

This register must be opened (and therefore the lever completely pushed), in detail, for the combustion of wood, so that unburnt carbon

can be subject to a post-combustion, increasing the yield and assuring the cleaning of the glass (see chapter NORMAL OPERATION). It is

possible to get the air SECONDARY directly from outside through a exible tube ( reproof NOT furnished Picture 11 Ref A).

The adjustment of the registers necessary to reach the rated caloric yield is the following one:

INSERTO

50 Crystal

INSERTO

50v Crystal

BII

INSERTO

50v p30

Crystal

INSERTO

70 Crystal

INSERTO

80 Cry EVO

2.0

INSERTO

80 Cry PRS

INSERTO

100 Crystal

Hourly consumption

( kg/h )

1,8 2,4 1,7 2,7 2,1 2,2 2,8

PRIMARY AIR CLOSED CLOSED CLOSED CLOSED CLOSED CLOSED CLOSED

SECONDARY AIR OPENED OPENED OPENED OPENED OPENED OPENED OPENED

TERTIARY AIR

PRE-

ADJUSTED

PRE-

ADJUSTED

PRE-

ADJUSTED

PRE-

ADJUSTED

PRE-

ADJUSTED

PRE-

ADJUSTED

FLUE

Essential requirements for a correct operation of the device:

• the internal section must be preferably circular;

• be thermally insulated and water-proof and produced with materials suitable to resist to heat, combustion products and

possible condensates;

• not be throttled and show a vertical arrangement with deviations not greater than 45°;

• if already used, it must be clean;

• all the sections of the ue gas duct must be accessible to inspection;

• inspection openings must be provided for cleaning.

• observe the technical data of the instructions manual;

Should the ues have a square or rectangular section, internal edges must be rounded with a radius not lower than 20 mm. For the rectangular

section, the maximum ratio between the sides must be = 1.5.

A too small section causes a decrease of the draught. It is suggested a minimum height of 4 m.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

La Nordica Inserto Crystal 50V P30 Seite 23

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info