Bedienungsanleitung La Nordica Isotta Forno (Seite 23 von 92) (Deutsch, Englisch, Französisch, Italienisch, Spanisch)

696164

Zoom out

Zoom in

Vorherige Seite

1/92

Nächste Seite

ENGLISH

ACCESSORIES

GIULIETTA x ISETTA EVO ISOTTA EVO ISOTTA FORNO

ISOTTA

FORNO EVO

VIOLA EVO VIOLETTA x

POKER

SERIES SERIES SERIES SERIES SERIES SERIES SERIES

GLOVE

SERIES SERIES SERIES SERIES SERIES SERIES SERIES

The heating of the environment is made by irradiation: through the panoramic glass and the external hot surfaces of the stove, the heat is

radiated into the environment. The device is equipped with registers of primary and secondary air by which it is adjusted the combustion air.

A - SECONDARY Air register Picture 6

Over the door of the hearth there is the secondary air control.

This regulator must be open (the lever must be moved to the right), especially for wood combustion, so that unburnt carbon undergoes

a post-combustion (see chapter NORMAL OPERATION).

Through this register it is possible to adjust the power of the stove. Leaving it slightly open, according to the ue of the chimney, it is

possible to keep the glass clean.

B - PRIMARY Air register Picture 6

With the thermostat (ISETTA EVO, ISOTTA EVO, VIOLA EVO) or valve (GIULIETTA x, VIOLETTA x) placed on the back of the right side of

the stove, it is adjusted the passage of air through the ash drawer and the grate in the fuel direction. The primary air is necessary for the

combustion process. The ash drawer must be regularly emptied, so that the ash does not obstruct the primary air entry. Through the

primary air the re is also kept alive.

During wood combustion, the register of primary air must be opened only for a while, because otherwise the wood burns fast and the

stove may overheat. For the correct arrangement (see paragraph NORMAL OPERATION).

The adjustment of the registers necessary to reach the rated caloric yield is the following one:

Mass of fuel hourly

kg/h

(A )

SECONDARY Air

(B)

PRIMARY Air

TERTIARY Air

GIULIETTA x 1,9 Picture 6 CLOSED PRE-CALIBRATED

ISETTA EVO 2,2 OPEN 5 mm CLOSED /

ISOTTA EVO 2,5 OPEN OPEN 5 mm /

ISOTTA FORNO 3,2 OPEN OPEN 5 mm /

ISOTTA FORNO EVO 2,6 Picture 6 CLOSED PRE-CALIBRATED

VIOLA EVO 2,2 OPEN 5 mm CLOSED /

VIOLETTA x 1,9 Picture 6 CLOSED PRE-CALIBRATED

C - IGNITION CONTROL Picture 6

Close --; Open + ( NO Isotta Forno EVO ) See chapter LIGHTING

Lighting Operation :

Open the secondary air register (A), primary air register (B), open the ignition control (C), light up the re.

After about 10 minutes, when the re is lighted, close the thermostat (B) and the ignition control (C) and adjust the combustion course

with the controls (A). The openings for air (primary and secondary) must be opened together just a little (you must open the eventual

buttery valve placed on the pipe of smokes exhaust). See chapter LIGHTING.

Load The Fuel:

Before opening the hearth door, open the ignition control (C), load the fuel, close the door and after about 5 or 10 minutes close the

control (C). IMPORTANT: we suggest you to open the door very slowly, to avoid the exit of smokes.

THE FLUE

Essential requirements for correct appliance operation:

• the internal section must preferably be circular;

• the appliance must be thermally insulated and impermeable and built with suitable materials which are resistant to heat,

combustion products and any condensation;

• there must be no narrowing and vertical passages with deviations must not be greater than 45°;

• if already used, it must be clean;

• all the sections of the ue gas duct must be accessible to inspection;

• inspection openings must be provided for cleaning.

• the technical data from the instruction manual must be respected;

If the ues are of a square or rectangular section, the internal edges must be rounded with a radius of not less than 20 mm.

For the rectangular section, the maximum ratio between the sides must be ≤ 1.5.

A section which is too small causes a reduction in draught. A minimum height of 4 m is advisable.

The following materials are FORBIDDEN and compromise the good operation of the appliance: asbestos cement, galvanised steel, rough and

porous internal surfaces. Picture 1 shows some example solutions.



For a correct installation please respect the sections/lengths of the ue shown in the technical data table. By installations

with dierent dimensions the ue must be suitably sized in accordance with EN13384-1.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

La Nordica Isotta Forno Seite 23

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von La Nordica Isotta Forno

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info