Bedienungsanleitung La Nordica Loriet S DSA (Seite 24 von 104) (Deutsch, Englisch, Französisch, Italienisch, Spanisch)

696191

Zoom out

Zoom in

Vorherige Seite

1/104

Nächste Seite

ENGLISH

• Make sure that the ue and the pipes to which the appliance will be connected are suitable for its operation. It is not allowed the

connection of various appliances to the same chimney.

• The diameter of the opening for connection to the chimney must at least correspond to the diameter of the ue gas pipe. The opening

must be equipped with a wall connection for the insertion of the exhaust pipe and a rosette.

• The installation must be appropriate and has to allow the cleaning and maintenance of the product and the ue.

Before installation, accurately wash the pipes of the system in order to remove any residuals that could compromise the correct functioning

of the appliance.

IMPORTANT:

a) It would be appropriate to install an automatic or manual air valve to allow the air outlet from the plumbing system;

b) In case of water leaking, close the water supply and promptly warn the after sales technical service;

c) The system working pressure must periodically be checked.

d) If not using the boiler for a long period of time, it is recommended that the after sales technical service is contacted to carry out at least

the following operations:

• close the water taps of both the thermal system and the domestic hot water system;

• empty the thermal system and the domestic hot water system if there is risk of freezing.

The DSA thermo appliances, can be installed in both an OPEN expansion Tank system and a CLOSED expansion Tank system .

La NORDICA S.p.A. declines all responsibility for damage to things and/or persons caused by the system. In addition, it is

not responsible for any product modied without authorisation and even less for the use of non original spare parts. Your

regular local chimney sweep must be informed about the installation of the appliance so that he can check the correct connection

to the chimney.

OPEN EXPANSION TANK SYSTEM

It is COMPULSORY that the OPEN expansion Tank system is provided with:

1. OPEN EXPANSION Tank: which has a capacity of 10% of total water content of thermo-product and of the installation. This is installed at

the highest point of the system, at least 2 m over the radiator that is at the highest level.

2. SAFETY PIPE : that connects through the shortest way, without descending or siphoning parts, the delivery of thermo-product to the

upper side of open expansion tank. ATTENTION: The inside diameter of the supply pipe which connects the thermoproduct with the

open expansion vessel must be equal to the internal diameter of the supply junction present in the thermoproduct. The above mentioned

connection pipe must be without siphoning parts.

3. LOAD PIPE : which connects the bottom of open expansion tank with the return pipe of installation. The minimum diameter must be ¾” gas.

All those parts must no have for any reason meditate intercept bodies that could accidentally exclude them and must be placed in rooms

which are protected from frost. On the contrary, if they freeze, the boiler body could break or even explode. In case of frost placing it will

be right to add a proper percentage of antifreeze liquid to the water of installation in order to delete the whole problem. In no way there

must be water circulation in the open expansion tank between the safety and loading pipe. This would cause the water oxygenation and

the consequent corrosion of thermo-product and installation in a very short time.

4. AUTOMATIC THERMAL DISCHARGE VALVE DSA which is a further positive safety that prevents the boiling even when electric energy is

missing. It is made by a valve cover like a pressure safety valve which diers from it as it opens by reaching a pre-calibrated temperature

(normally at 94 – 95°C) and unload hot water from the installation delivery. This will be replaced with as much cold water coming from the

open expansion tank loading pipe of open tank by draining away the excessive heat.

5. SAFETY VALVE FROM 1,5 bar: maximum operation pressure allowed for the system is 1,5 bar (equal to 15 m of the water column). Higher

pressures can cause deformation and breakage of the boiler body.

6. SAFETY DEVICES envisioned by Regulations in vigour.

7. CIRCULATION PUMP : . It would be better to install it on the return in order to avoid that it could disconnect itself at very high water

temperatures but checking that it does not drive water in the open expansion tank otherwise it should cause a continuous water oxygenation

with consequent, fast corrosion of boiler body. It must be not to avoid a forced circulation in the open expansion tank. Furthermore it must

be electrically connected to a thermostat or a electronic control unit that can be purchased with the thermo-replace as OPTIONAL part.

8. ANTI-CONDENSATION MIXING VALVE – (see chapter)

ATTENTION: temperature safety sensors must be in place on the machine or at a distance no greater than 30 cm from the ow

connection of the thermo-product. Whenever the thermo products lack a device, those missing can be installed on the thermo

product ow pipe, within a distance no greater than 1m from the thermo product. All those parts must no have for any reason

meditate intercept bodies that could accidentally exclude them and must be placed in rooms which are protected from frost. On

the contrary, if they freeze, the boiler body could break or even explode.

ATTENTION: For no reason must the re be ignited before the system has been completely lled with water; doing this

would lead to serious damage of the entire structure. The system must be lled by means of the loading pipe directly from the

open tank in a way to prevent an excessive pressure of the water network deforming the body of the thermo heating stove.



The system must be kept constantly full of water even during the periods when the use of the thermo-heating stove is not requested.

During the winter, inactivity must be faced with the addition of antifreeze.

La Nordica Loriet S DSA Seite 24

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info