Bedienungsanleitung La Nordica MARIAROSA (Seite 24 von 84) (Deutsch, Englisch, Französisch, Italienisch, Spanisch)

811773

Zoom out

Zoom in

Vorherige Seite

1/84

Nächste Seite

ENGLISH

The cooker is equipped with controls of primary and secondary air by which it is adjusted the combustion air.

1A - PRIMARY Air Register (Picture 6).

With the lower register, the passage of primary air in the lower part of the cooker is regulated through the ash drawer and the grill in the

direction of the fuel. The primary air is necessary for the combustion process. The ash drawer must be emptied regularly, so that the ash

cannot block the primary air intake for combustion. The primary air also keeps the ame alive.

The primary air register must be almost completely closed during wood combustion, as otherwise the wood burns too quickly and the stove

may overheat.

2A - SECONDARY Air Register (Picture 6).

This register must be open (i.e. turned completely to the right), in particular for the combustion of wood (see Table).

The register regulation necessary in order to obtain nominal caloric output is the following (see Cap. TECHNICAL DATA):

Hourly consumption kg/h PRIMARY air SECONDARY air TERTIARY air

Picture 6 OPEN PRE-ADJUSTED

B - FLUE GAS Control (Picture 6)

(Conversion from the stove Radiant-plate USE function to the stove HEAT ACCUMULATOR function)

On the right of the front of the stove, between the protection rail and the heat accumulator door, is the SMOKE CONTROL LEVER, recognisable

as a bronze knob. When the lever is pushed towards the back of the stove, the combustion gases ow above the oven directly towards the

exhaust stub (stove function – Radiant-plate USE); when the lever is pulled towards you, the combustion gases ow all around the heat

accumulator, so the internal temperature increases evenly (stove function – heat ACCUMULATOR USE).

To ignite the ame follow the instructions below (see Cap. IGNITION) :

• Open the FLUE GAS Register (stove function – Radiant-plate USE) to aid ue gas exhaust. Position the register (any buttery valve placed

on the ue gas exhaust pipe must also be opened).

• Open the primary air register (placed on the ash tray).

• After having started the re with small pieces of wood and waited until it is well lit.

• Bring the ue gas register to the heat ACCUMULATOR position.

• Close the any buttery valve placed on the ue gas exhaust pipe must also be opened.

The control regulation during the ignition phase is the following:

PRIMARY air SECONDARY air FLUE GAS Control

OPEN OPEN stove function – Radiant-plate USE

THE FLUE

Essential requirements for correct appliance operation:

• the internal section must preferably be circular;

• the appliance must be thermally insulated and impermeable and built with suitable materials which are resistant to heat,

combustion products and any condensation;

• there must be no narrowing and vertical passages with deviations must not be greater than 45°;

• if already used, it must be clean;

• all the sections of the ue gas duct must be accessible to inspection;

• inspection openings must be provided for cleaning.

• the technical data from the instruction manual must be respected;

If the ues are of a square or rectangular section, the internal edges must be rounded with a radius of not less than 20 mm.

For the rectangular section, the maximum ratio between the sides must be ≤ 1.5.

A section which is too small causes a reduction in draught. A minimum height of 4 m is advisable.

The following materials are FORBIDDEN and compromise the good operation of the appliance: asbestos cement, galvanised steel, rough and

porous internal surfaces. Picture 1 shows some example solutions.



For a correct installation please respect the sections/lengths of the ue shown in the technical data table. By installations

with dierent dimensions the ue must be suitably sized in accordance with EN13384-1.

The draught created by your ue must be sucient but not excessive.

A section of the ue which is too large can present a volume which is too large to heat and therefore cause operating diculties for the

appliance; to avoid this, it is necessary to intubate the appliance for its entire height. A section which is too small causes a reduction in draught.

ATTENTION: as far as concern the realisation of the ue connection and ammable materials please follow the requirements

provided by UNI 10683 standard. The ue must be at a suitably distance from ammable or combustible material using

suitable insulation or an air space.

It is FORBIDDEN to pass system piping or air ducts inside the ue. It is also forbidden to create moveable or xed openings on

the ue itself, for the connection of further dierent appliances (See chapter CONNECTING A FIREPLACE OR OPEN HEARTH TO THE

FLUE).

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

La Nordica MARIAROSA Seite 24

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info