812600
24
Zoom out
Zoom in
Vorherige Seite
1/36
Nächste Seite
MANUAL FOR USE AND MAINTENANCE
24 LSC 001 -UK- REV. 06
3.2 ALARM CONTROL
The appliance is run by a program that controls the correct operation of its functions and in case one or
more of these is not properly performed, the display will signal the relevant alarm message together with
an acoustic signal.
NOTE. Messages can be divided into two different types: blocking and non-blocking alarms.
Blocking alarms block the appliance completely and to make it work again, it is necessary to switch it
off completely and to switch it on again using the main switch (3).
The non-blocking ones do not block the appliance or its functions and it is necessary to press the button
to cancel them.
Loss of data
This alarm is not a blocking one.
It appears when the main running program of the appliance cannot nd the parameters set at installation
(temperature and dose settings) in the memory and therefore, the appliance will continue to operate but
with default data (standard).
(If this alarm appears, it is necessary to have the appliance reprogrammed by an authorised Service
Centre).
High temperature
This alarm is not a blocking one.
It appears when the main running program of the appliance recognises a boiler temperature value
that is 5 °C higher than the preset temperature. If this alarm appears, the static relays are temporarily
disconnected.
Temperature probe failure
This alarm is a blocking one.
It appears when the main control program of the appliance recognises that the boiler temperature sensor
is not operating within the correct range:
Temperature lower than 50 °C 20 minutes after switching on (manual or by timer) or in real time, during
normal operation; sensor disconnected
Temperature higher than 140 °C (only during normal operation); short circuited sensor (if this alarm
appears, call an authorised Service Centre immediately).
Automatic water lling system
This alarm is a blocking one.
It appears when the main control program of the appliance signals that the automatic water lling system
has been operating for more than 4 minutes (if the problem persists, switch off the appliance and contact
an authorised Service Centre).
Transformer failure
This alarm is a blocking one.
It appears when the main control program of the appliance signals that the power (24 V) of the transformer of
the solenoid valves is below 13 V (if this alarm appears, call an authorised Service Centre immediately).
AL00
AL01
AL02
AL03
AL04
24

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für La Spaziale RAPID wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info