Bedienungsanleitung Laica VT3108 (Seite 10 von 36) (Deutsch, Englisch, Französisch, Italienisch, Portugiesisch, Spanisch)

677552

Zoom out

Zoom in

Vorherige Seite

1/36

Nächste Seite

18 19

FUNCTION DESCRIPTION

1. " " Button: press this button at the end of each operating cycle to

lift the lid.

2. Indicator lights: show the phases of the operating cycle:

• POWER: indicates the beginning of the operating cycle;

• FREE HAND: you can take your hand off the lid;

• SEAL: indicates the sealing phase.

3. Sealing bar: seals the bag.

4.5 Suction and liquid collection chamber: area where the open end

of the bag is positioned to allow air suction and the elimination of any

excess liquids.

6. Sealing gasket: creates an excellent sealing effect in the suction

chamber to be able to perform the vacuum in the bags.

7. Sealer gasket: ensures the bag touches the sealing bar.

8. “ON” button:

• This button is automatically activated when the lid is pressed;

• Press the "ON" button with your hand only for vacuum sealing

with LAICA reusable bags.

9. Lid: Creates the sealing effect needed to generate the vacuum in the

bag.

TECHNICAL DATA

- Voltage: 220V 50Hz

- Electrical absorption: 100W

- Vacuum value (approx): -0.75 bar

- Environmental operating conditions:+10°C +40°C;

relative humidity ≤85%

- Environmental storage conditions: +10°C +50°C;

relative humidity ≤85%

- MAX bag width: 250 mm

The bags and rolls included are for food

INSTRUCTIONS FOR USE

PREPARATION

• Before each use, thoroughly clean the appliance as described in the

section "maintenance".

• Position the machine on a sturdy horizontal surface, being careful to

leave the work zone around the appliance free of obstacles and large

enough to allow for placing the bags of food to be packaged.

• Connect the appliance to a power outlet.

• Uniformly insert the food to be stored in the bag. Make sure the bag is

about 8 cm longer than the food to be stored.

• Lift the lid.

USE WITH BAGS

1. Position the open end of the bag inside the vacuum chamber as shown

in ﬁgure 2 without covering the air suction hole. With Laica bags codes

VT3501, VT3503 and VT3504, and Laica rolls code VT3508, put the

bag with the smooth side facing upwards. Make sure the sealing point,

inside of the bag, is clean and free of any particle of food. The bag

must be perfectly stretched and without any creases.

2. Lower the lid and press ﬁrmly with your hands on both sides of the

same: the machine automatically starts the vacuum process.

3. Take your hands off the lid when the indicator light "FREE HAND" turns

on.

4. When the indicator light "SEAL" turns off, press “ ” and lift the lid.

5. Check the bag seal and place it in the refrigerator, freezer or storeroom.

USE WITH ROLLS

The roll allows you to prepare bags of desired length, suitable for the food

to be preserved.

1. Set the bag length considering the length of the food to be preserved

and add at least 8 cm.

2. Cut the roll to the desired size using sharp scissors.

3. Place one of the two open ends of the bag on the sealing gasket.

With Laica rolls code VT3508, place the smooth side facing upwards.

Do not let the bag to come out from the vacuum chamber and drip tray

or the seal gasket. Make sure that the bag is fully stretched out, clean

and unwrinkled.

4. Lower the lid and press ﬁrmly with both hands on either side of the

same.

5. When the indicator light "SEAL" turns off, press “ ” and lift the lid.

6. Check the seal made.

7. Continue as described in "PRELIMINARY OPERATIONS" and

"OPERATING INSTRUCTIONS - HOW TO USE THE SEALER WITH BAGS"

sections.

VACUUM PACKING FOR LIQUIDS

To vacuum pack liquids they should be pre-frozen.

Put the liquid food in a suitable container, put it in the freezer for about

12-18 hours then remove it from the container and put it in the bag

for vacuum packing. Remove the air and seal the bag as in section

"Instructions for use - use with bags" then put the bag in the freezer.

MAINTENANCE

• Wash hands thoroughly before cleaning the appliance.

• Before and after use, clean the appliance with a dry or slightly damp

cloth, being careful to not let liquids penetrate inside.

• After each use, remove any nylon (bag) reside from the sealing bar

using a soft cloth and being careful not to damage it. Clean the

sealing bar only after it has cooled.

• After each use, thoroughly clean the suction and liquid collection

chamber with a damp cloth to remove any residues.

• Never use chemicals or harsh products.

• Store the appliance in a cool, dry area.

• The following parts are available at your retailer: sealer gasket and

sealing gasket: code AHI012.

TROUBLESHOOTING

Problem Possible cause Solution

The appliance is not

working.

The appliance is not

plugged in.

Plug the product into the

electrical socket.

The thermoprotector

was triggered.

Let the appliance cool for

at least 30 minutes and

turn it back on.

Let the appliance cool

for at least 30 minutes

and turn it back on.

The bag may be

punctured.

Make sure the bag is intact

or replace it.

English English

EN EN

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Laica VT3108 Seite 10

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info