Bedienungsanleitung Laica VT3112 (Seite 10 von 36) (Deutsch, Englisch, Französisch, Italienisch, Portugiesisch, Spanisch)

677551

Zoom out

Zoom in

Vorherige Seite

1/36

Nächste Seite

18 19

excess liquids.

4. Sealing gasket: creates an excellent sealing effect in the suction

chamber to be able to perform the vacuum in the bags.

5. Sealer gasket: ensures the bag touches the sealing bar.

6. “ON” button:

• This button is automatically activated when the lid is pressed;

• Press the "ON" button with your hand only for vacuum sealing

with LAICA reusable bags.

7. Lid opening buttons: to unhook the lid.

8. Lid: Creates the sealing effect needed to generate the vacuum in the

bag.

9. Locking levers: hook the lid to the base of the machine.

TECHNICAL DATA

- Voltage: AC 220-240V 50Hz

- Electrical absorption: 90W

- Vacuum value (approx): -0.75 bar

- Environmental operating conditions:+10°C +40°C;

relative humidity ≤85%

- Environmental storage conditions: +10°C +50°C;

relative humidity ≤85%

- MAX bag width: 300 mm

The bags and rolls included are food grade

INSTRUCTIONS FOR USE

PREPARATION

• Before each use, thoroughly clean the appliance as described in the

section "maintenance".

• Position the machine on a sturdy horizontal surface, being careful to

leave the work zone around the appliance free of obstacles and large

enough to allow for placing the bags of food to be packaged.

• Connect the appliance to a power outlet.

• Uniformly insert the food to be stored in the bag. Make sure the bag is

about 8 cm longer than the food to be stored.

• Lift the lid.

USE WITH BAGS

1. Position the open end of the bag inside the vacuum chamber as shown

in ﬁgure 2 without covering the air suction hole. With Laica bags codes

VT3500, VT3501, VT3502, VT3503, and VT3504 and Laica rolls

codes VT3505, VT3508, and VT3509, set the bag with the smooth

side facing the bottom. Make sure that the inside of the bag where

sealing will be performed is clean and free of any food particles. It

must lie ﬂat without folds.

2. Lower the lid and ﬁrmly press on the two sides with both hands,

hooking the two blocking levers at the bottom of the appliance until

you hear a "click". The machine automatically starts the vacuum

process and the bag sealing cycle.

3. At the end of the automatic cycle (vacuum and sealing), press the two

buttons to open the lid and raise it.

4. Make sure the bag is sealed and put it in the refrigerator, freezer, or

pantry.

USE WITH ROLLS

The roll lets you make bags in the length desired and that are suited to

the food to be stored.

1. Establish the length of the bag considering the length of the food to be

stored and adding at least 8 cm.

2. Cut the roll in the desired measurement using sharp scissors.

3 . Put one of the two open ends of the bag on the sealer gasket. With

Laica rolls codes VT3505, VT3508, and VT3509, set the smooth side

facing the bottom. Do not allow the bag to extend in the suction and

liquid collection chamber or on the sealing gasket.

Make sure the bag lies ﬂat and is clean and without folds.

4. Lower the lid and ﬁrmly press on the two sides with both hands,

hooking the two blocking levers at the bottom of the appliance until

you hear a "click". The machine automatically starts the roll sealing

process.

5. At the end of the sealing cycle, press the two buttons to open the lid.

6. Check the seal made.

7. Proceed as described in sections "PREPARATION" and "INSTRUCTIONS

FOR USE - USE WITH BAGS".

VACUUM PACKING FOR LIQUIDS

To vacuum pack liquids they should be pre-frozen. Put the liquid food

in a suitable container, put it in the freezer for about 12-18 hours then

remove it from the container and put it in the bag for vacuum packing.

Remove the air and seal the bag as in section "Instructions for use - use

with bags" then put the bag in the freezer.

MAINTENANCE

• Wash hands thoroughly before cleaning the appliance.

• Before and after use, clean the appliance with a dry or slightly damp

cloth, being careful to not let liquids penetrate inside.

• After each use, remove any nylon (bag) reside from the sealing bar

using a soft cloth and being careful not to damage it.

Clean the sealing bar only after it has cooled.

• After each use, thoroughly clean the suction and liquid collection

chamber with a damp cloth to remove any residues.

• Never use chemicals or harsh products..

• Store the appliance in a cool, dry area.

• Do not store the appliance with the lid hooked to the base

using the locking levers so that the sealer and sealing gaskets

are not damaged.

• The following parts are available at your retailer: sealer gasket and

sealing gasket: code AHI006.

TROUBLESHOOTING

Problem Possible cause Solution

The appliance is not

working.

The appliance is not

plugged in.

Plug the product into

the electrical socket.

The thermoprotector

was triggered.

Let the appliance cool

for at least 30 minutes

and turn it back on.

Let the appliance cool

for at least 30 minutes

and turn it back on.

The bag may be

punctured.

Make sure the bag is

intact or replace it.

Let the appliance cool

for at least 30 minutes

and turn it back on.

The bag is not

positioned correctly in

the suction and liquid

collection chamber.

Position the bag as

described in section

"Instructions - use with

bags".

English English

EN EN

Laica VT3112 Seite 10

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info