ASSEMBLY INSTRUCTIONS
1) Grab the lower column and place it close to the base and connect the electrical chip to this one. Insert the end of the
column in the base of the apparatus until the screw holes are correctly lined up.
2) Once the parts are in place, tilt the apparatus to the side and use 6 M8x35 screws to assemble the base and the
column. For every screw add 1 M8.1 washer and one M8.2 lock nut.
To make the assembly easier, we suggest you set up the appropriate screws, and then tighten them half way. Once
this stage has been accomplished, you can tighten them completely.
3) Assemble the upper column to the lower column. Place one part facing the other in order to connect both electrical
chips. Then fit together the 2 assemblies using the M6x20 screw.
4) Take the parts which make up the handles and connect the electrical cables, as indicated in the diagram. Use 2 M6x15
screws to assemble the lower part of the handles to the column. For every screw add an M6 lock nut.
5) Do the same on the other side, by correctly fitting together both upper parts of the handle.
6) Assemble the two upper parts of the handle. Use the two M6x0.5 screws.
7) Assemble and fit together the tab over the junction of both parts of the handle.
Your apparatus is ready to operate.
CONTROLS
Main control panel
1. Cardiac rate screen
2. Power button
3. Mode display screen
4. Increase time button
5. Time regulation selection button
6. Digital time screen
7. Decrease time button
8. Duo button to switch over to the double function
mode: oscillating-vibrating
9. "Up and down" button to switch over to oscillating
mode
10. Different mode selection button
