703314

Lancom 1780EW-4G plus Anleitung

1
Zoom out
Zoom in
Vorherige Seite
1/1
Nächste Seite
LANCOM, LANCOM Systems and LCOS are registered trademarks. All other names or descriptions used may be trademarks or registered
trademarks of their owners. Subject to change without notice. No liability for technical errors and/or omissions. 111581/0817
Please observe the
following when setting
up the device
a For devices to be
operated on the
desktop, please attach
the adhesive rubber
footpads
a Do not rest any objects
on top of the device
a Keep the ventilation
slots on the side of
the device clear of
obstruction
a In case of wall
mounting, use the
drilling template as
supplied
a Rack installation with
the optional LANCOM
Rack Mount (not
supplied)
LANCOM 1681V
Power
VDSL
Online
ETH 1
ETH 2
VPN
ETH 3
ETH 4
ISDN Status
Hardware
Power supply 12 V DC, external power adapter 230 V with bayonet connector to secure against
disconnection
Power consumption Approx. 13 W via external power adapter (value refers to the overall power for the router and
power adapter); about 14 W via PoE (IEEE 802.3at)
Environment Temperature range 0–35 °C; humidity 0–95 %, non-condensing.
Temperature range 0–40 °C when mounted vertically on a LANCOM wall mount with cables
running to the side.
Housing Robust synthetic housing, rear connectors, ready for wall mounting,Kensington lock;
measures 210 x 45 x 140 mm (W x H x D)
Number of fans None; fanless design, no rotating parts, high MTBF
Interfaces
WAN, LAN 10 / 100 / 1000 Base-TX, autosensing, auto node hub
Serial Interface Serial conguration interface / COM port (8-pin Mini-DIN): 9,600–115,000 baud, suitable for
optional connection of analog/GPRS modems. Supports internal COM-port server and provides
transparent asynchronous serial-data transfer via TCP.
WLAN: Ant 1, Ant 2 Two reverse SMA connectors for external LANCOM AirLancer antennas or for antennas from
other vendors**
4G: Ant 1, Ant 2 Two SMA connectors for the supplied dipole rod antennas (LTE, UMTS), compatible LANCOM
AirLancer Extender antennas for 4G or 3G, or from other manufacturers**
GPS SMA jack for connecting an optionally available GPS antenna
WAN protocols
Ethernet PPPoE, Multi-PPPoE, ML-PPP, GRE, EoGRE, PPTP (PAC or PNS), L2TPv2 (LAC or LNS) and IPoE
(with or without DHCP), RIP-1, RIP-2, VLAN, IPv6 over PPP (IPv6 and IPv4 / IPv6 Dual Stack
Session), IP(v6)oE (Autoconguration, DHCPv6 or static)
Data transmission in cellular networks
Supported standards UMTS, HSxPA, HSPA+, LTE, LTE Advanced
Supported cellular
network bands
Band 1 (2100 MHz), band 2 (1900 MHz), band 3 (1800 MHz), band 4 (2100 MHz),
band 5 (800 MHz), band 7 (2600 MHz), band 8 (900 MHz), band 12 (700 MHz),
band 13 (700 MHz), band 20 (800 MHz), band 25 (1900 MHz), band 26 (800 MHz),
band 29 (700 MHz), band 30 (2300 MHz), band 41 (2500 MHz)
Maximum transmission
power
+23 dBm
GPS Positioning with the additional GPS antenna (optional)
Declaration of Conformity
Hereby, LANCOM Systems declares that this radio equipment is in compliance with Directive 2014/53/EU. The full text
of the EU declaration of conformity is available at the following internet address: www.lancom-systems.com/ce/
Package content
Documentation Quick Reference Guide (DE/EN), Installation Guide (DE/EN)
Cables 2 Ethernet cables, 3 m (LAN: kiwi-colored connectors; WAN: green connectors)
Antennas Two 3dBi dipole dualband antennas; two LTE / 4G antennas for LTE / UMTS
Power adapter External power supply adapter 230 V, NEST 12 V / 1.5 A DC/S, barrel connector 2.1 / 5.5 mm
bayonet, LANCOM item no. 111301 (EU, 230 V), LANCOM item no. 111302 (UK, 230 V)
a Power
Off Device switched off
Green, permanently Device operational,
resp. device paired / claimed and LANCOM
Management Cloud (LMC) accessible
Green / orange, blinking Conguration password not set. Without a
conguration password, the conguration
data in the device is unprotected.
1x green inverse
blinking*
Connection to the LMC active, pairing OK,
device not claimed
2x green inverse
blinking*
Pairing error, resp.
LMC activation code not available
3x green inverse
blinking*
LMC not accessible, resp.
communication error
f VPN
Off VPN connection inactive
Green, permanently VPN connection active
Green, blinking Establishing VPN connections
e ETH
Off No networking device attached
Green, permanently Connection to network device operational,
no data trafc
Green, ickering Data transmission
SETTING UP AND CONNECTING THE DEVICE
TECHNICAL DATA
b WLAN
Off No Wi-Fi network dened or Wi-Fi module
deactivated. The Wi-Fi module is not
transmitting beacons.
Green, permanently At least one Wi-Fi network is dened and
Wi-Fi module activated. The Wi-Fi module
is transmitting beacons.
Green, inverse ashing Number of ashes = number of connected
Wi-Fi stations and P2P wireless connec-
tions, followed by a pause (default).
Alternatively the frequency of the ashing
can indicate signal strength over the
dened P2P link or the signal strength
between the access point and the device
operating in client mode.
Green, blinking DFS scanning or other scan procedure
c 4G
Off Cellular interface disabled
Green,permanently Connection to cellular network active
Green, ickering Cellular data transmission
Orange, permanently Logon to cellular network successful
Orange, blinking Logging on to cellular network
Red, permanently Hardware error/module unavailable
Red / green, blinking SIM card error (PIN)
Red / orange, blinking Uploading module rmware
d SIGNAL
Off No cellular reception
Green, permanently Good signal strength,
greater than or equal to -70 dB
Orange, permanently Medium signal strength,
eld strength between -86 and -71 dB
Orange, blinking Low signal strength,
eld strength less than -87 dB
**) Please respect the restrictions which apply in your country when setting up an antenna system (in particular the
antenna gain and transmission power). For information about calculating the correct antenna setup, please refer to
www.lancom-systems.com.
This product contains separate open-source software components which are subject to their own licenses, in particular
the General Public License (GPL). The license information for the device rmware (LCOS) is available on the device‘s
WEBcong interface under “Extras > License information“. If the respective license demands, the source les for the
corresponding software components will be made available on a download server upon request.
When working with separately purchased antennas, please ensure you
do not exceed the maximum permissible transmission power. The system
operator is responsible for adhering to the threshold values.
Antennas are only to be attached or changed when the device is switched
off. Mounting or demounting antennas with the device switched on may
cause the destruction of the 4G or WLAN modules!
*) The additional power LED statuses are displayed in 5-seconds
rotation if the device is congured to be managed by the LANCOM
Management Cloud.
LANCOM 1780EW-4G+
4G
SIGNAL
ETH 2
Power
ETH 1
WLAN
VPN
a c eb fd
LANCOM 1780EW-4G+
Quick Reference Guide
Cloud-ready
MODEM
SIM
e f g h
a acbc
a
LTE / 4G antennas
Connect the two supplied cellular
antennas to the connectors located
at the device‘s sides.
b
GPS antenna (optional)
Connect the GPS antenna (free of
charge) to the connector GPS
(see included voucher).
c
WLAN antennas
Screw the two supplied WLAN anten-
nas onto the connectors WLAN Ant 1
and WLAN Ant 2. The desired MIMO
behaviour can be congured under
> Physical WLAN Settings
> Radio
> Antenna grouping
d
Power
When connecting the cable to the
device, turn the bayonet connector
90° clockwise until it clicks into place.
Use only the supplied power adapter.
e
Serial interface
Conguring the device via the serial interface
requires a serial conguration cable
(available as an accessory).
f
WAN interface
Use the cable with the green-colored con-
nectors to connect the interface ETH2 to your
WAN modem.
g
Ethernet interface
Use the cable with the kiwi-colored connectors
to connect the interface ETH1 (PoE) to your PC
or a LAN switch.
h
Optional: SIM card
Slide the SIM card into the slot using the
marker to ensure that the card is the right way
round. Ensure that the SIM card clicks into
place on insertion. To remove the card from
the device again, press the card lightly into
the device. Let go to release the SIM card from
the slot.
SIM
d
5
The SIM card is only to be inserted or removed when the device is switched off.
Inserting or removing the SIM card with the device switched on may cause the destruction of
the 4G module!
5
4

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Lancom 1780EW-4G plus wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Andere Handbücher von Lancom 1780EW-4G plus

Lancom 1780EW-4G plus Kurzanleitung - Deutsch - 1 seiten

Lancom 1780EW-4G plus Installationsanweisung - Deutsch - 18 seiten

Lancom 1780EW-4G plus Installationsanweisung - Englisch - 18 seiten


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info