Bedienungsanleitung Landmann 42303 - Avalon 3 (Seite 43 von 135) (Englisch, Französisch, Spanisch)

685292

Zoom out

Zoom in

Vorherige Seite

1/135

Nächste Seite

Avalon 3 Burner Gas Grill

A Natural gas hose and quick connect are not

supplied with this product but are available as an

accessory for purchase from your local dealer.

1. A professionally-installed shut-off valve between

the supply piping and the socket is always

recommended, but but may not be required,

by the National Fuel Gas Code. The socket

connection must always be made outdoors.

2. Coat the gas supply pipe nipple with gas resistant

pipe dope or teﬂon tape. Screw socket on gas as

supply pipe ( house gas souce) shown in Figure A

below, and wrench-tighten.

3. Pull back the sleeve on the quick disconnect

socket and insert the unattached end of the gas

hose into the socket. Release the sleeve and

continue pushing the hose into the socket until

the sleeve snaps into the locked position. See

Figure B.

4. When the quick disconnect socket and the gas

hose are connected, a valve in the socket opens

automatically to permit full gas ﬂow. When the

gas hose is disconnected, the valve in the socket

instanly and positively shuts off the ﬂow of gas.

Because the valve in the socket positively shuts off

the ﬂow of gas, the grill can be disconnected from the

gas source by disconnecting the gas hose from the

quick disconnect socket. The socket should be left

attached to the gas source ( house piping) Figure C

below, shows properly connected hose and socket.

With proper assembly, the gas hose connot be

removed without pushing the quick disconnect sleeve

back. To disconnect, push sleeeve back and pull plug

out of sleeve (this automatically shuts off gas).

Please Note: Only hose and assemblies that are

C.S.A. listed for natural gas, manufactured gas,

mixed gas and for liqueﬁed petroleum and for LP

Gas-Air mixtures on basis of 0.64 speciﬁc gravity

for 1000 BTU’s per cubic foot of gas at 0.3 in. water

column pressure drop. Only ANSI Z21.54 approved

hose should be used with this grill.

The appliance and its individual shut off valve must

be disconnected from the gas supply piping system

during any pressure testing on that system at test

pressures in excess of 1/2 psig (3.5kPa).

The appliance must be isolated from the gas supply

piping system by closing its individual manual shutoff

valve during any pressure testing of the gas supply

piping system at test pressure equal to or less than

1/2 psi (3.5kPa).

Connecting Grill to A Natural Gas Source

The quick disconnect socket should

never be connected to the grill. Direction

of gas ﬂow is indicated on the socket.

Figure A

Figure C

Figure B

Quick disconnect socket

Gas hose Sleeve

House piping

Do not use hard metal piping of any kind

to connect this type of grill to natural

gas source. Use only hose speciﬁed by

manufacturer. Using hard metal piping

or convoluted metal tubing is an unsafe

pratice. Movement of the grill can cause

breakage of metal pipe.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Landmann 42303 - Avalon 3 Seite 43

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info