ᕤ Open your board to the desired
height. Fit the cover according to the
instructions below.
ᕥ Lift the lid of the storage box and
gently remove the clips.Take out the iron,
the monotube, the silicon mat and the
power cord.
ᕦ Close the lid ensuring that it is firm-
ly in place.
2
Setting up
Installation
ᕡ Ensure the lid is closed. ᕢ Place the board vertically on its
point with the steam generator facing
upwards.
ᕣ Tip the board forward while
depressing on the handle for adjusting
the height of the table.
Cover
Slide the cover over the ironing board passing the rubber strap under the lid,between
the board and the lid.Adjust it on the lid of the storage box.Then adjust it at the front
of the board.
If you require a new cover contact your retailer or customer service agent.
Accessories
Silicon mat (code 508.0001.703): The logo on the mat should be facing
upwards.The mat is used to place the hot iron on.Do not place the iron on any other
surface.This could cause severe damage.
Measuring beaker: the beaker allows you to refill the steam generator reservoir eas-
ily.
English
