Bedienungsanleitung Laurastar Go (Seite 4 von 8) (Englisch)

778244

Zoom out

Zoom in

Vorherige Seite

1/8

Nächste Seite

- 5 - - 6 -

Two ironing modes

For the best possible steam ironing result, we offer two modes of

ironing :

• Press the STEAM button (10) to generate steam and activate the fan

in blower mode.

• Blower mode : this blows air onto the fabric from below, helping to

reduce unwanted creases. B

• Vacuum mode : this draws in air, holding the garment in place on the

board to facilitate perfect pleats. C

• Press the VACUUM/BLOWER button (11) to switch from blower to

vacuum mode and vice versa.

Advice : to improve the quality of ironing and increase the autonomy of

your appliance, iron the fabric once using steam, then a second time

without steam to dry the fabric.

Protective soleplate (8)

The protective soleplate is indispensable for dark-coloured fabrics which

can become shiny and for synthetic fabrics which have a tendency to

stick to the iron.

Using the protective soleplate :

• First place the tip of the iron (2) at the front of the protective

soleplate (8) and lower the iron to x it in place in the soleplate. D

• Wait approximately 2 minutes for the soleplate to reach the correct

temperature.

• To remove the protective soleplate (8), pull on the tab and remove the

iron while it is still hot. E

WARNING : The protective soleplate and the iron

are hot ! Use caution when you remove the protective

soleplate.

NOTICE : ALWAYS remove the protective soleplate after use.

Switching on your appliance

• Insert the plug in the socket.

• Press the On/Off switch (15), the blue indicator light will ash for 8

to 10 minutes. B

• When the blue indicator light stops ashing and remains on, the

appliance is ready. You can start ironing.

NOTE : For your comfort and safety, your Laurastar system will

switch off after 10 minutes of non-use.

NOTE : Before ironing, or after an extended break, press the

iron’s steam button 2 or 3 times, while pointing it away from the

clothes. This will release any condensation from the iron and

prevent water marks on the clothes.

CAUTION : Do not point the iron at people or pets while

using vertical steam.

Setting the temperature of the iron

Set the thermostat (9) to • • or • • •. A

NOTE : After changing the temperature setting, it takes

approximately 2 minutes before the new temperature is

stabilized.

Steam principle

Perfect ironing requires diffusion of steam across the fabric, in order

to relax the bres, and drying to x them in place. Creases can only be

completely removed if these conditions are present. For best results,

rst iron the item with steam and then iron it again without steam,

thereby enabling the iron to dry the fabric.

Ironing

Setting the temperature and

using the soleplate

Indication on

the clothing Iron setting Protective

soleplate Material

D• • with

Extremely delicate man-made fabrics. E.g.

synthetic velvet, Alcantara® (synthetic suede),

“stretch” sports clothing, microfibre fabrics,

polyamide/polyester, viscose, polyurethane

E• • • with Wool, silk, synthetic fabrics

F• • • without Cotton, linen, aramide

Ironing mode

Fabric type Velvet

Blowing Back Darts

Inside and

linings,

sleeves

Top and

pleats •••

Vacuum Buttons

and collar

Turn-ups

and pleats

Buttons and

collars Pleats •

B B

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Laurastar Go Seite 4

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Laurastar Go

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info