Bedienungsanleitung Laurastar Smart (Seite 6 von 10) (Deutsch, Englisch, Holländisch, Französisch, Italienisch, Portugiesisch, Spanisch, Polnisch)

778224

Zoom out

Zoom in

Vorherige Seite

1/10

Nächste Seite

- 10 -

3-6 min.

- 9 -

NOTE: Before ironing, or after an extended break, press the iron’s

steam button (9) 2 or 3 times, while pointing it away from the clothes.

This will release any condensation from the iron and prevent water

marks on the clothes.

CAUTION : Do not point the iron at people or pets while using

vertical steam.

Ironing

Two ironing modes

For the best possible steam ironing result, we offer two modes of ironing :

• Blower mode : A Pressing the vacuum/blower button (10) on the iron

activates the fan (24) in blower mode. this blows air into the fabric from

below, helping to reduce unwanted creases.

• Vacuum mode : B Pressing the vacuum/blower button (10) again,

activates the fan (24) in vacuum mode. This draws in air, holding the

garment in place on the board to facilitate perfect pleats.

Press the vacuum/blower button (10) to switch from blower to vacuum mode

and vice versa. You can adjust the intensity (4 speeds) pressing the fan speed

button (19) on the user interface of the steam generator.

LAURASTAR SENSTEAM (17) (certain models only)

Laurastar SenSteam (17) allows you to obtain an automatic steam diffusion

without pressing the steam button (9). The steam is automatically activated

when the iron moves forward and stops when the iron rests or moves back

To switch back to regular mode, press the Laurastar SenSteam button (17)

again.

PULSE (18) (certain models only)

Press the pulsed steam button (18) to activate the pulse function. Then press

the steam button (9) to automatically generate small and regular steam jets

D. To switch back to regular mode, press the pulsed steam button again (18).

Steam principle

Perfect ironing requires diffusion of steam across the fabric, in order to relax

the ﬁbres, and drying to ﬁx them in place. Creases can only be completely

removed if these conditions are present.

Advice: For best results, ﬁrst iron the item with steam and then iron it again

without steam, thereby enabling the iron to dry the fabric.

Protective soleplate (27)

The protective soleplate is indispensable for dark-coloured fabrics which can

Start up

CAUTION: Always ﬁll the water reservoir (11) completely

before turning on your Laurastar. Operating the appliance

without water could damage the appliance.

PLEASE NOTE: Operating the appliance without water will void any

limited warranties provided with your appliance.

Installation of the anti-scale cartridge and ﬁlling

• Check that the power plug is disconnected from the mains socket.

• Set the ironing board to its highest position.

• Take the water reservoir (11) out. Take off the water reservoir lids.

Install the anti-scale ﬁlter (13). A

• Fill the reservoir with tap water. The ﬁltered water has to reach the

MAX level. B

• Close the water reservoir with the lids and put the reservoir back on the

steam generator (15).

• If the water does not ﬂow, soak the anti-scale ﬁlter in cold water for 3

minutes.

User interface

• ON/OFF = the green indicator light ﬂashes until the appliance is ready to

be used.

• = Option Laurastar SenSteam. If your appliance is equipped with the

Laurastar SenSteam option (17), the white indicator light signals that the

function is on.

• = Option Pulsed Steam. If your appliance is equipped with the Pulsed

Steam option (18), the white indicator light signals that the function is ON.

Fan speed button (19) = choice of four speeds. The white indicator light

signals the intensity chosen.

• Empty water light (20) = the red drop shaped indicator light signals that

there is no more water in the reservoir (11).

Switching on your appliance

• Insert the power plug (23) in the socket. If your model is equipped with the

automatic rewinder, ﬁrst pull the electric cable untill the end-of-cable mark

is visible at the rewinder opening.

• Press the main ON/OFF button (16), the green indicator light will ﬂash for

3-6 minutes. C

• When the green indicator light stops ﬂashing and stays on, the appliance is

ready. You can start ironing.

• NOTE: For your comfort and safety, your Laurastar system will

switch off after 10 minutes of non-use.

ON/OFF

SenSteam

Pulse

Fan speed

Water

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Laurastar Smart Seite 6

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Laurastar Smart

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info