Bedienungsanleitung Lavorwash XTR 1007 (Seite 19 von 128) (Alle Sprachen)

733408

Zoom out

Zoom in

Vorherige Seite

1/128

Nächste Seite

· Vent the unit before operation.

· Unscrew the high-pressure line at the high-pressure

outlet of the unit.

· Switch on the unit and let it run until water free of

bubbles emerges at the high-pressure outlet.

· Switch oﬀ the unit and screw on the high-pressure

hose again.

Failure to comply with the above conditions

causes serious mechanical damage to the

pump and the loss of warranty cover.

> ELECTRICITY SUPPLY

- The appliance’s electrical connection must

comply with the IEC 60364-1 standard.

IMPORTANT:

Before connecting the ap-

pliance, make sure that the nameplate data

are the same as those of the electrical mains

and that the socket is protected by a diﬀer-

ential security breaker with tripping sensitiv-

ity below 0.03 A - 30 ms.

- If the appliance’s plug is not compatible

with the socket, have the socket replaced

with another of suitable type by profession-

ally qualiﬁed staﬀ.

- Never use the appliance in ambient temper-

atures below 0° C if it is equipped with a PVC

(H VV-F) cable.

• XY WARNING: Inadequate extension cords

can be dangerous.

• XJ WARNING: If an extension cord is used,

the plug and socket must be of watertight

construction.

Information for supply may also be obtained

from the plug manufacturer.

<16 A <25 A

<20 m ø 1,5 mm

14 AWG

ø 2,5 mm

12 AWG

20 m - 50 m ø 2,5 mm

12 AWG

ø 4,0 mm

10 AWG

> PLUG

HOW TO CONNECT THE CORD TO A U.K. PLUG:

IMPORTANT The wires in the mains lead are col-

oured in accordance with the following code:

Blue Neutral

Brown Live

Yellow/Green Earth

Please read the instructions given below before con-

necting the cord to a plug. If in doubt please consult

a qualiﬁed electrician.

As the colours of the

wires in the mains

lead of this appliance

may not correspond

with the coloured

markings identifying

the terminals in your

plug, proceed as fol

lows: The wires that is

coloured Brown must

be connected to the

terminal which is

marked with the let

ter L or coloured Red. The wire that is coloured Blue

must be connected to the terminal wich is marked

with the letter N or coloured Black. Safety points for

rewireable or moulded plug: The mains lead of this

appliance may be already fitted with a BS1363 13A

plug.

- If your socket outlet is not suitable for the plug, then

the plug must be removed (cut oﬀ if it is a mould

ed on plug), the ﬂexible cord insulation should be

stripped back as appropriate and a suitable 3 pin

plug ﬁtted.

•

WARNING: Dispose of a plug that has been cut from

the power supply cord, as such a plug is hazardous

if inserted in a live 13A socket outlet elsewhere in

the house. - Should the fuse need to be replaced

an ASTA marked fuse, approved to BS1362, of the

same rating must be used. - Always replace the fuse

cover after ﬁtting a fuse. The plug must NOT be used

if the cover is omitted or lost until a replacement is

obtained. - Make certain that only the correct fuse

cover is used and ﬁtted. - For plugs with detachable

fuse cover the replacement must be the same as the

colour insert in the base of the plug, or as directed by

the embossed wording on the base of the plug. - If

the detachable fuse cover is lost a replacement may

be purchased from a Service Centre.

( if ﬁtted)

NOTE:

(Automatic Stop System),

which stops the machine during the bypass phase.

To start the water cleaner, it is therefore necessary to

set the switch on position (I)“ON”; after that press the

pistol trigger: the Automatic Stop System will start

the machine and will stop it automatically when

the trigger is released. It is advisable to put on the

safety of the pistol trigger whenever the machine is

stopped, in order to avoid unintentional starting.

4 -

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Lavorwash XTR 1007 Seite 19

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info