Bedienungsanleitung Leica S 007 (Seite 46 von 72) (Englisch)

594983

Zoom out

Zoom in

Vorherige Seite

1/72

Nächste Seite

Recording mode

FLASH EXPOSURE DISPLAYS IN THE VIEWFINDER WITH SYSTEM-

COMPATIBLE FLASH UNITS

In the viewﬁnder display of the Leica S, a ﬂash symbol serves as a feed-

back and display of various operating states.

•

does not appear despite the ﬂash unit being switched on and ready

for use:

In such cases the Leica S will not ﬁre the ﬂash unit even though it is

switched on and ready for use. (e.g. because the wrong operating mode

is set on the ﬂash unit)

•

ﬂashes before the picture is taken:

– The ﬂash unit is not yet ready to use

•

is lit up before the picture is taken:

– The ﬂash unit is ready for use

•

continues to light up constantly after ﬁring:

– The ﬂash is still ready to use.

• In the case of a ﬂash exposure compensation set at the ﬂash unit

– ± appears additionally in the viewﬁnder as an indicator

FLASH PHOTOGRAPHY WITH THE FLASH UNIT-INTEGRATED AUTO-

MATIC COMPUTER

When working with the automatic exposure of system-compatible ﬂash

units, the light reﬂected by the subject is metered and evaluated by a

sensor integrated into the ﬂash unit, not by the camera. The exposure

operating modes of the camera function essentially in the same way as

without ﬂash. If the ﬂash sync speed drops below the set value with

P or

A , or a speed is set below the sync speed with T or M, the ﬂash is not

triggered.

As the operating modes, and already generate a normally exposed pic-

ture due to the ambient lighting, the ﬂash power should be reduced, i.e. a

ﬂash exposure compensation of e.g. –1EV to –2EV should be set.

With system-compatible ﬂash units, the aperture set at the lens is trans-

mitted to the ﬂash unit and automatically taken as the basis as computer

aperture. For the metering, the sensitivity set at the camera and any

exposure compensation set for the ambient lighting (camera) and ﬂash

(ﬂash unit) are taken into consideration.

MANUAL FLASH PHOTOGRAPHY WITH CONSTANT FLASH POWER

If the ﬂash unit is used in manual ﬂash mode with full power or ﬁxed

partial power (if this can be set at the ﬂash unit), the emitted ﬂash light

power is not controlled. The exposure operating modes of the camera

function essentially in the same way as without ﬂash.

If the ﬂash sync speed drops below the set value with

A or T , or a speed

is set below the sync speed with

T or M, the ﬂash is suppressed. The lens

aperture to be set is determined by the ﬂash power, sensitivity and

distance to the subject, or vice versa, the ﬂash partial power to be set is

determined by the aperture, sensitivity, focal length and distance to the

subject (see ﬂash unit manual).

FLASH PHOTOGRAPHY VIA THE X CONTACT

No information is transmitted if a non-system-compatible ﬂash unit is

connected via the accessory shoe. As the camera cannot "recognize"

such a ﬂash unit, it acts as if no ﬂash unit were attached. The ﬂash time

must be set manually to the ﬂash sync speed

⁄125s, or

⁄1000s with central

shutter, or to slower speeds; an automatic changeover does not take

place. The ﬂash unit ready and indicator lamps are not active.

If the ﬂash unit is suitable, the light control can be performed with an

automatic aperture, i.e. via the sensor on the ﬂash unit, or manually by

selecting corresponding partial light power levels (see ﬂash unit manual).

FLASH PHOTOGRAPHY VIA THE LOWER LEMO

JACK

Flash units and large studio ﬂash systems can be connected by cable

with LEMO

plug (supplied) can be connected to the lower LEMO

jack.

The LEMO

jack with its automatic locking reliably prevents an inadver-

tent interruption in the connection. As the camera cannot "recognize" a

ﬂash unit connected in this way, it acts as if no ﬂash unit were attached.

The ﬂash time must be set manually to the ﬂash sync speed

⁄125s, or

⁄1000s

with central shutter, or to slower speeds; an automatic changeover does

not take place. The ﬂash unit ready and indicator lamps are not active.

Inhalt_EN.indd 42 20.08.2015 14:14:45

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Leica S 007 Seite 46

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Leica S 007

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info