Bedienungsanleitung Leica S2 (Seite 43 von 89) (Englisch)

585257

Zoom out

Zoom in

Vorherige Seite

1/89

Nächste Seite

Shutter speed priority - T

Setting the mode

1. Set the shutter speed dial (1.10) to the required value.

2. If necessary, press the click wheel (1.18) to set automatic

aperture control, i.e. in this case shutter speed priority mode.

The lens aperture is then controlled automatically based on the

available light and continuously between a fully open and mini-

mum aperture for the relevant lens.

Viewfinder and top panel display show

• T (speed priority) for the selected exposure mode (2.5.c/3.8),

• the automatically set aperture value (2.6/3.11), and

• the manually set shutter speed value (2.8a/3.12)

Notes:

• If automatic sensitivity setting is activated at the same time

(see p. 30), the control range for shutter speed priority is

extended. Any maximum shutter speed set as part of the

automatic sensitivity setting does not override this.

• With very little light or extreme brightness, the available aper-

ture range of the lens you are using may no longer be suffi-

cient for the selected shutter speed. Set a different shutter

speed if possible. However, a correct exposure is normally

still used in such cases, by automatic setting of the appropri -

ate shutter speed, i.e. by “overriding” your manual selection.

may also appear to warn you that you are below the mete-

ring range (see p. 36). It is then no longer possible to correctly

meter the exposure.

Manual aperture and shutter speed setting - m

Setting the mode

1. Set the shutter speed dial (1.10) to the required value.

2. Press the click wheel (1.18) to set the aperture to manual

control.

3. Turn the click wheel to set the required aperture.

Viewfinder and top panel display show

• m for the selected exposure mode (2.5.d/3.8),

• the manually set aperture (2.6/3.11) and shutter speed

values (2.8a/3.12), and

• a light balance (2.7), which assists in adjusting the exposure.

The light balance shows the deviation of the set shutter-

speed/aperture combination from the metered exposure value.

The display clearly shows the range ± 3 EV in

EV steps. Larg-

er deviations are shown with flashing of the outer markings on

the light balance scale. To achieve the correct exposure according

to the result of the exposure metering, the aperture and/or

shutter speed should be adjusted until the zero marking lights

up on the light balance.

Note:

If automatic sensitivity setting is activated at the same time

(see p. 30), the last manually set sensitivity is used. Any

maximum shutter speed set as part of the automatic sensitivity

setting has no effect.

The B setting

The B (bulb) setting keeps the shutter open as long as the shut-

ter release button remains pressed (maximum 32s).

In conjunction with the self-timer, an additional T function is

also available: If you set B and activate the self-timer by pres-

sing the shutter release button (see also p. 40), the shutter

opens automatically after the selected delay time. It then

remains open until you press the shutter release button a

second time – you do not need to hold the button down. This

enables you to largely prevent any blurring, even with long expo-

sures, by pressing the shutter release button. The exposure

meter remains off in both cases.

The viewfinder shows

• (2.8c) instead of a shutter speed

The top panel display shows

• B (3.13), and

• after opening the shutter, the elapsed exposure time in

seconds (3.12)

Notes:

• Long exposure times can be associated with very heavy picture

noise. To reduce this annoying phenomenon, after pictures

with slow shutter speeds the LEICA S2 automatically takes a

second „black picture“ (taken with the shutter closed). The

noise present in this parallel picture is then digitally “subtrac-

ted” from the data set for the real picture.

• This doubling of the „exposure“ time can be significant in par-

ticular at longer exposures and must be considered. During

this time the camera should not be switched off.

• For shutter speeds of >

s the message Noise Reduction

appears in the monitor.

• Long time exposures using the B setting are produced using

only the focal plane shutter inside the camera, even if the

main switch (1.15) is set to CS (see p. 21).

Shutter speed priority / Manual mode / The B setting / 39

Inhalt_GB.qxp:Leica M8 deutsch 11.12.2009 10:24 Uhr Seite 39

FIRMWARE

UPDATE

FIRMWARE

UPDATE

FIRMWARE

UPDATE

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Leica S2 Seite 43

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Leica S2

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info