654230

Lelit Diana PL60 PlusTR1 Seite 7

7
Zoom out
Zoom in
Vorherige Seite
1/20
Nächste Seite
7
English
22. Press the toggle steam switch (9) up paying attention that the steamer always stays immerse in the liquid, to avoid
possible hot drink sprays.
23. Press the toggle steam switch (9) down to stop steaming and remove the steam tube (10) from the cup/mug.
24. The steam tube (10) can become extremely hot so make sure to handle it only touching the rubber safety protection.
25. Clean the steam tube (10) accordingly with a normal damp cloth.
Hot water:
26. Check that the tank contains water. ATTENTION: the internal tank has a special floating device that controls the water
level. In case of lack of water, the water missing pilot light (17) comes on automatically and at the same time the sound
allarm buzzes. Please fill the water tank with water (as described under Starting the machine, points 3-5): this will shut
off the pilot light (17) and the buzzer, confirming that the water level is suitable. NB: the water tank must be filled in
with water till the MAX level indicated on the appliance body.
27. Wait till the PID’s (16) display shows the set temperature and the coffee ready pilot light (4) goes off.
28. Place a mug under the hot water faucet (11) and press the hot water switch (20) up: the pilot light (21) confirms the
starting. Once you get the desired amount of hot water press the switch (20) down to stop dispensing.
29. After having taken hot water, always check that there is still water in the tank and if it is necessary, fill the water tank
with water.
HOW TO SET THE BOILER’S TEMPERATURE BY MEANS OF THE PID:
The PID has been set by the producer of this machine on a temperature of 95°C. In order to change the temperature
please proceed as follows:
4. press the button ; as soon as the display shows the writing “PRG” press the button ;
5. as soon as the display shows the boiler’s temperature, help yourself with the buttons and in
order to set the desired temperature, starting from a min. of 80C° up to a max. of 130C°.
6. after 3 sec. from pressing the last button, the inserted temperature is memorized and the display shows the set
temperature.
NB: if the temperature is set too high, once a coffee request is made, the display starts to flash.
ROUTINE MAINTENANCE AND PRECAUTIONS:
− Clean up the steam tube (10) after every use.
− Use a normal damp cloth to clean the machine.
− Do not leave the machine outdoors.
− Do not immerse the machine in water.
− Use the machine only under adult control and keep it away from children’s reach.
− Do not wash filters and filter holder in the dishwasher.
− During normal functioning some parts of the appliance body can reach high temperatures: please handle with due
caution!
− The PID is already set by the producer on the right temperature for an excellent espresso. During heating and
coffee or water distribution, the temperature can oscillate (+/- 10/12°C). A warning has been also inserted:
after 113°C the PID’s display shows the temperature but intermittently; this is normal: it warns the user that
the coffee will not be good if made with such high temperature.
ATTENTION: the machine is equipped with a water tank of 2.7l with missing water sensor connected to an allarm pilot light
(17) and also to a buzzer. The sound of the buzzer caused by the lack of water at starting the machine is different from the
sound made to indicate the lack of water during normal funtioning. The restoration of the suitable water level will shut off
the allarm pilot light (17) and the buzzer. If the water finishes during the normal funtioning the missing water sensor will
allow 15sec. of time to finish the coffee; once the coffee is done the water tank must be filled with water till the max level
indicated on the appliance body.
We suggest reading the instruction booklet carefully and checking the water level in the water tank regularly.
Water softener included (inserted on the plastic tube, inside the water tank): one way water softener for espresso
machines. It protects the machine from limestone residues. It needs to be replaced according to the water hardness and
consumption following the below table:
Water hardness
Quantity
10°F 90 lt
20°F 45 lt
27°F 35 lt
35°F 23 lt
45°F 20 lt
NB: It’s is necessary to replace the resin filter as indicated above otherwise the limestone residues can damage the coffee
machine (the warranty does not cover this type of damage).
… 7 …

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Lelit Diana PL60 PlusTR1 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info