POWER ON AND OFF
PRESS THE POWER BUTTON TO TURN THE UNIT ON OR OFF.
ANTENNA
FOR FM RECEPTION LAY OUT THE EXTERNAL FM WIRE ANTENNA AND ADJUST DIRECTION, FOR
OPTIMUM RECEPTION.
DO NOT CONNECT THIS WIRE TO ANY OUTDOOR ANTENNA .
POWER SUPPLY
GB 2
OPERATION WITH AC POWER
1. PLEASE CAREFULLY CHECK THAT THE VOLTAGE INDICATED ON YOUR SET CORRESPONDS TO
THE VOLTAGE OF YOUR LOCAL AREA.
2. INSERT THE AC POWER CORD INTO AN AC OUTLET.
NOTE : WHEN INSERTED A BACK UP BATTERY THE UNIT WILL CONSERVE THE SETTINGS DURING
POWER OUTAGE.
THE DISCONNECT DEVICE SHALL REMAIN READILY OPERABLE.
BATTERY BACKUP
THE CLOCK TIME AND ALARM SETTINGS CAN BE PROTECTED AGAINST POWER FAILURE BY A 9V
BATTERY ( NOT SUPPLIED ) . IN THE EVENT OF A POWER FAILURE , THE DISPLAY IS BLANK , BUT
THE CLOCK TIME AND ALARM SETTINGS ARE HELD IN MEMORY. WHEN THE POWER INTER-
RUPTION ENDS, THE DISPLAY APPEARS AGAIN . ( DURING A POWER INTERRUPTION , THE CLOCK
TIME MAY GAIN OR LOSS A FEW MINUTES PER HOUR AND MAY REQUIRE RESETTING . )
BATTERY INSERTION
1 . REMOVE THE COVER OF THE BATTERY COMPARTMENT ( ON THE BOTTOM OF THE UNIT).
2 . CONNECT A 9V BATTERY ( AN ALKALINE - TYPE BATTERY IS RECOMMENDED ) TO THE
BATTERY TERMINAL INSIDE THE COMPARTMENT .
3 . PLACE THE CONNECTED BATTERY IN THE COMPARTMENT AND REPLACE THE COVER .
FOR OPTIMUM PERFORMANCE , THE BATTERY SHOULD BE REPLACED EVERY 6 MONTHS.
REMOTE TEMPERTURE SENSOR
1. REMOVE THE FOUR SCREWS FROM THE BATTERY COMARTMENT WITH A SCREWDRIVER.
2. INSTALL TWO AAA/LR03 ( 1.5V) SIZE BATTERIES MATCHING POLARITIES SHOWN IN THE
BATTERY COMPARTMENT.
3. TIGHTEN THE SCREW.
NOTE: FOR OPTIMUM , THE BATTERY SHOULD BE REPLACED EVERY 10 MONTHS. OR WHEN THE
OUTDOOR READINGS CANNOT BE DISPLAYED PROPERLY.
FITTING THE BATTERIES
THE CLOCK
TO SET THE TIME
1. PRESS AND HOLD THE TIME SET BUTTON
2. PRESS THE HOUR BUTTON TO SET HOURS.
3. PRESS THE MINUTE BUTTON TO SET MINUTES.
4. RELEASE THE TIME SET BUTTON. THE CORRECT TIME IS SHOWN ON THE DISPLAY.
