9
INSTALLING THE BATTERIES FOR CLOCK BACKUP
The clock will be maintained during a power failure by installing 2 x AAA / LR03 batteries (not supplied). Once the power is restored,
check the clock to make sure it is accurate and set it again if necessary.
INSTALLING THE BATTERIES
1. Open the battery compartment at the bottom of the unit by pressing on the catch and removing the cover.
2. Insert 2 x AAA / LR03 batteries (not supplied), preferably alkaline batteries, into the battery compartment following the polarity as
shown on the diagram inside the compartment.
3. Replace the battery compartment cover.
CONNECTING TO THE POWER SUPPLY
Plug the AC power cable into the AC wall socket.
BASIC OPERATION
Press the STANDBY button to turn on the unit. To turn off, press and hold the STANDBY button again.
Alternatively press the STANDBY button on the remote control to turn on or turn off the unit.
DAB+ / FM / BT
When the unit is turned on, press the SOURCE button to toggle between DAB+, FM and Bluetooth mode.
Volume Control
Press the VOLUME + / - buttons to change the volume.
Adjusting the Antenna
The antenna wire at the rear panel of the unit should be fully extended to ensure a good DAB+/FM reception. Alter the antenna position
for the best reception.
DAB+ OPERATION
The first time the DAB+ mode is selected, it will automatically scan for available DAB+ stations. Wait until the scanning has finished.
The display will show the scanning progress. After scanning it will tune to the first station.
Auto Scan
1. Turn on the unit in DAB+ mode.
2. Press the SCAN button to start auto-scanning the available stations.
Manual Scan
1. Turn on the unit in DAB+ mode.
2. Press and hold the INFO / MENU button on the unit (or press the MENU button on the remote control) to access the menu control.
3. Press the or button (the TUNE / TUNE button on the remote control) until “Manual tune” is displayed and then
press the ENTER button.
4. Press the or button (the TUNE / TUNE button on the remote control) to select the desired channel (5A-13F).
5. Press the ENTER button to confirm.
6. To select another channel (5A-13F), press the or button (the TUNE / TUNE button on the remote control) and
then press the ENTER button to confirm.
7. To quit manual scan, press the MENU button.
Tuning
Press the or button (the TUNE / TUNE button on the remote control) to display the information of the next station.
Then press the ENTER button to tune to this station within a few seconds.
