Bedienungsanleitung Leonard LI1315 (Seite 30 von 48) (Englisch, Holländisch, Dänisch, Französisch)

638899

Zoom out

Zoom in

Vorherige Seite

1/48

Nächste Seite

Using the detergent

BA D

1. Press the release button (B) to open

the lid (C).

Put the detergent in the compartment

(A) .

If the programme has a prewash

phase, put a small quantity of deter-

gent in the compartment (D).

If you use detergent tablets, put the

tablet in the compartment (A).

Close the lid. Make sure that the re-

lease button locks into position.

Using the combi detergent tablets

When you use tablets, that contain salt and

rinse aid, do not fill the salt container and

the rinse aid dispenser.

1. Adjust the water softener to the lowest

level.

2. Set the rinse aid dispenser to the lowest

position.

If you stop to use the combi detergent

tablets, before you start to use

separately detergent, rinse aid and

dishwasher salt, do these steps:

1. Press the on/off button to activate the

appliance.

2. Set the water softener to the highest

level.

3. Make sure that the salt container and

the rinse aid dispenser are full.

4. Start the shortest programme with a

rinsing phase, without detergent and

without dishes.

5. Adjust the water softener to the water

hardness in your area.

6. Adjust the released quantity of rinse aid.

Setting and starting a programme

Setting mode

The appliance must be in setting mode

to start a programme.

• Turn the programme knob until the pro-

gramme marker is aligned with a pro-

gramme on the control panel. If the on/off

indicator comes on and the phase indica-

tors for the programme start to flash, the

appliance is in setting mode.

• Turn the programme knob until the pro-

gramme marker is aligned with a pro-

gramme on the control panel. If the on/off

indicator and the start indicator come on

and a phase indicator is on with fixed

light, the appliance is not in setting mode.

To put the appliance in setting mode, press

and hold the start button until the start indi-

cator goes off and the phase indicators for

the programme start to flash.

Starting a programme

1. Open the water tap.

2. Close the appliance door.

3. Turn the programme knob until the pro-

gramme marker is aligned with the pro-

gramme you want to set.

• The on/off indicator comes on.

• The phase indicators of the set pro-

gramme start to flash.

4. Press the start button. The programme

starts.

• The start indicator comes on.

• Only the indicator of the phase in op-

eration stays on.

Opening the door while the appliance

operates

If you open the door, the appliance stops.

When you close the door, the appliance

continues from the point of interruption.

Cancelling the programme

Press and hold the start button until the

start indicator goes off and the phase indi-

cators for the programme start to flash.

Make sure that there is detergent in the

detergent dispenser before you start a

new programme.

At the end of the programme

When the programme is completed, the

end indicator comes on.

30 leonard

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Leonard LI1315 Seite 30

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Leonard LI1315

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info