558493
22
Zoom out
Zoom in
Vorherige Seite
1/34
Nächste Seite
- 20 -
Place the temperature regulator 7 into the position
"MAX".
Heat the steam iron up for several minutes at this
highest setting.
Remove the steam iron from the station q
(see chapter “Tips for utilisation”).
Then iron a piece of material that is no longer
required, to remove possible contamination from
the sole of the iron e.
Tips for utilisation
In addition to the typical utilisation with a cable,
you can also separate the steam iron from the cable
base 8 for a short period to iron textiles which are
not located close to an electrical power socket.
To separate the steam iron from the cable base 8:
Place the steam iron, with the cable base 8
engaged, onto the station q. The unlocking
switch 0 must be in the position .
Slide the unlocking switch 0 into the
position . The steam iron now allows itself
to be lifted off. The cable base 8 remains
combined with the station q.
Note:
As the steam iron cannot be heated up without the
cable base 8, you can only work for a short period
without the cable base 8. Reconnect the steam iron
with the cable base 8 as soon as the steam blast
or the ironing quality diminishes.
To reconnect the steam iron with the cable base 8:
Insert the steam iron into the cable base 8
connected to the station q. Slide the unlocking
switch 0 to . You can now lift the steam
iron with the cable base 8 from the station q.
Should you wish to secure the steam iron to the
station q, for safekeeping for example, slide the un-
locking switch 0 with the preplaced steam iron to .
The steam iron can now no longer be removed from
the station q.
Operation
Filling with mains water
In a cooled condition, place the steam iron
horizontally on its sole e.
Slide off the cover of the filler opening for the
water tank 2.
Using the measuring beaker, fill the water tank
with water to the "Max" marking, but no further.
Slide the cover of the filler opening for the water
tank 2 back to close it.
Note
Should the mains water at your locality be rated as
hard, it is recommended that you mix mains water
with some distilled water. Otherwise, the jets for the
steam blast function could calcify (become blocked)
prematurely.
To extend the optimal steam blast function, mix
mains water with distilled water according to the
table.
IB_KH1283_E40978_LB5 23.09.2008 14:47 Uhr Seite 20
22

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln
1

Forum

lervia-kh-1283

Suche zurücksetzen

  • Ich habe versehentlich das Bügeleisen vor Abreise nicht abgeschaltet. Nach Rückkehr fand ich es außer Funktion.
    Sicherung (wo?) durchgebrannt? Kein Thermostat, der es verhindert? Muß es jetzt zum Elektromüll? Eingereicht am 11-9-2018 08:24

    Antworten Frage melden

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Lervia KH 1283 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Andere Handbücher von Lervia KH 1283

Lervia KH 1283 Bedienungsanleitung - Deutsch, Holländisch, Französisch - 26 seiten


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info