Bedienungsanleitung LG 65LA9650 (Seite 5 von 40) (Englisch)

613949

Zoom out

Zoom in

Vorherige Seite

1/40

Nächste Seite

ENGLISH

IMPORTANT SAFETY INSTRUCTIONS

Dot Defect

The Plasma or LCD panel is a high technology product

with resolution of two million to six million pixels.

In a very few cases, you could see fine dots on

the screen while you’re viewing the TV. Those

dots are deactivated pixels and do not affect the

performance and reliability of the TV.

Generated Sound

Cracking noise: A cracking noise that occurs

when watching or turning off the TV is generated

by plastic thermal contraction due to temperature

and humidity. This noise is common for products

where thermal deformation is required.

Electrical circuit humming/panel buzzing: A

low level noise is generated from a high-speed

switching circuit, which supplies a large amount of

current to operate a product. It varies depending

upon the product.

This generated sound does not affect the

performance and reliability of the product.

Take care not to touch the ventilation openings.

When watching the TV for a long period, the

ventilation openings may become hot. This does

not affect the performance of the product or

cause defects in the product.

If the TV feels cold to the touch, there may be a

small flicker when it is turned on. This is normal,

there is nothing wrong with TV. Some minute dot

defects may be visible on the screen, appearing

as tiny red, green, or blue spots. However, they

have no adverse effect on the TV’s performance.

Avoid touching the LCD screen or holding your

finger(s) against it for long periods of time. Doing

so may produce some temporary distortion

effects on the screen.

Preventing Image burn or Burn-in on

your TV screen

If a fixed image displays on the TV screen for

a long period of time, it will be imprinted and

become a permanent disfigurement on the

screen. This is image burn or burn-in and not

covered by the warranty.

If the aspect ratio of the TV is set to 4:3 for a

long period of time, image burn may occur on the

letterboxed area of the screen.

Avoid displaying a fixed image on the TV screen

for a long period of time (2 or more hours for LCD,

1 or more hours for the Plasma TV) to prevent

image burn.

For USA and Canada

FCC NOTICE

This equipment has been tested and found to

comply with the limits for a Class B digital device,

pursuant to Part 15 of the FCC Rules. These limits

are designed to provide reasonable protection

against harmful interference in a residential

installation. This equipment generates, uses

and can radiate radio frequency energy and, if

not installed and used in accordance with the

instructions, may cause harmful interference

to radio communications. However, there is no

guarantee that interference will not occur in a

particular installation. If this equipment does

cause harmful interference to radio or television

reception, which can be determined by turning the

equipment off and on, the user is encouraged to

try to correct the interference by one or more of

the following measures:

- Reorient or relocate the receiving antenna.

- Increase the separation between the

equipment and the receiver.

- Connect the equipment to an outlet on

a circuit different from that to which the

receiver is connected.

- Consult the dealer or an experienced radio/TV

technician for help.

This device complies with part 15 of the FCC

Rules. Operation is subject to the following two

conditions: (1) this device may not cause harmful

interference and (2) this device must accept any

interference received, including interference that

may cause undesired operation of the device.

Any changes or modifications in construction of

this device which are not expressly approved by

the party responsible for compliance could void

the user’s authority to operate the equipment.

NOTE TO CABLE/TV INSTALLER

This reminder is provided to call the CATV system

installer’s attention to Article 820-40 of the

National Electric Code (U.S.A.). The code provides

guidelines for proper grounding and, in particular,

specifies that the cable ground shall be connected

to the grounding system of the building, as close

to the point of the cable entry as practical.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

LG 65LA9650 Seite 5

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info