20 Air Conditioner
Operating Instructions
Forced operation
Forced operation is used when the remote controller can't be used. The operation will be started if the ON/OFF
button is pressed. If you want to stop the operation, re-press the button.
Heat pump Model
Cooling Model
Room Temp. ≥ 24°C21°C ≤ Room Temp. < 24°C Room Temp. < 21°C
Operating mode Cooling Cooling Healthy Dehumidification Heating
Indoor FAN Speed
High High High High
Setting Temperature
22°C22°C23°C24°C
Test operation
During the TEST OPERATION, the unit operates in cooling mode at high speed fan, regardless of room temperature
and resets in 18 minutes.
During test operation, if remote controller signal is received, the unit operates as remote controller
sets.
If you want to use this operation, Press and hold the ON/OFF button for 3~5 seconds, then the buzzer sound 1
'beep'. If you want to stop the operation, re-press the button.
Open the front panel. Press the ON/OFF button.
So you can operate the air
conditioner.
➀ Lift up the front panel
after approximately 25
seconds.
➁ Fold the supporter.
➂ Close the front panel.
Press the front panel as
shown until hearing
"clicking" sounds.
Open the front panel. Press the ON/OFF button.
So you can turn off the air
conditioner.
Fold the supporter after
approximately 25 seconds.
Close the front panel.
Press the front panel as
shown until hearing
"clicking" sounds.
If you do not have the remote controller around here, you can start to operate the forced operation.
If you force to close the front panel, some parts may be damaged.
So you must follow the below step. (Only premium type)
