Owner's Manual 13
ENGLISH
Energy-Saving Cooling Mode (Optional)
Operating Instructions
Energy-saving cooling mode can save energy in cooling operation, because it can operate efficiently by
setting body-adaptation time according to the change of time and temperature and adjusting desired
temperature automatically .
1. Press the START/STOP BUTTON to start the unit.
2. Open the door on the remote controller. Select cooling operation.
3. Press the ENERGY-SAVING COOLING MODE BUTTON.
4.
To cancel the energy-saving cooling mode, press the ENERGY-SAVING COOLING
MODEL BUTTON AGAIN AND UNIT WILL OPERATE IN COOLING MODE.
Forced operation
Operation procedures when the remote control can't be used.
The operation will be started if the ON/OFF button is pressed.
If you want to stop operation, re-press the button.
Heat pump Model
Cooling Model
Room Temp. ≥ 24°C21°C ≤ Room Temp. < 24°C Room Temp. < 21°C
Operating mode Cooling Cooling Healthy Dehumidification Heating
Indoor FAN Speed
High High High High
Setting Temperature
22°C22°C23°C24°C
Test operation
During the TEST OPERATION, the unit operates in cooling mode at high speed fan, regardless of room
temperature and resets in 18 minutes.
During test operation, if remote controller signal is received, the unit operates as remote controller sets.
If you want to use this operation, Press and hold the ON/OFF button for 3~5 seconds, then the buzzer sound
1 "beep". If you want to stop the operation, re-press the button.
Display Luminosity
The Display Luminosity can be adjusted by using the remote control.
Press the start/stop button to start the unit. Open the door on the remote control, press the 2ndF button
and press display luminosity button.
Then, display will be off after activated 10 seconds during STARTing operation or by pressing any button
on the remote controller. After the display will be activated 10 seconds, it retains 50% luminosity or off
whenever you press the button.
In case of requesting initial operating mode judgement, the indoor unit running air circulation operation
during 15 second. And then, operating by room temperature condition. (mentioned below Table)
