Advanced functions on your Video
Your Video has some advanced operations with features you may find useful.
CM (Commercial
Message) Skip
This enables you to skip past small
sections of the video tape, such as
commercial messages, television
adverts or film trailers.
Press the CM SKIP button on the
remote control, during play.
Each subsequent press of the button
increases the amount of the tape
which is skipped by 30 seconds, up
to a total of three minutes
(180 seconds). After the chosen time
has passed normal play will
automatically resume.
OPR (Optimum Picture
Response)
This enhances the picture from the
video tape by adjusting to the
condition of the video tape. If you feel
that the picture needs adjusting you
can manually change the OPR
setting.
You can only set OPR when a tape is
playing in the Video.
1 Press to enter the main menu.
2 Use 1 or 2 to select OPR then
press OK.
3 Use the 3 or 4 buttons to select
OFF, SOFT or SHARP.
4 Press to exit the menus.
Colour standards
Your Video uses dual colour
standards, PAL B/G and
SECAM B/G. During play your Video
should select the Colour System
automatically, however if you
experience problems you may need
to do it manually.
1 Press to enter the main menu.
2 Use 1 or 2 to select SYSTEM
then press OK.
3 Use 3 or 4 to select the colour
system used in your recording.
PAL Signals
(Playback or recording mode)
NTSC Signals (Playback mode)
NTSC PB:
Use when playing back a tape
recorded in the NTSC system on
PAL TV.
NTSC 3.58:
Use when playing back a tape
recorded in the NTSC system in 3.58
mode.
NTSC 4.43:
Use when playing back a tape
recorded in the NTSC system in 4.43
mode.
NTSC Signals (Recording mode)
NTSC 3.58:
Use when recording NTSC 3.58
signals.
NTSC 4.43:
Use when recording NTSC 4.43
signals.
4 Press to exit the menus.
10
