Bedienungsanleitung LG GMJ916NSHV (Seite 10 von 52) (Englisch)

600355

Zoom out

Zoom in

Vorherige Seite

1/52

Nächste Seite

INSTALLATION

ENGLISH

Choosing the Proper Location

Select a place where a water supply can

be easily connected for the automatic

icemaker.

The fridge should always be plugged

into its own individual properly

grounded electrical outlet rated for

230 Volts, 50 Hz, AC only, and fused

at 15 or 20 amperes. This provides the

best performance and also prevents

overloading house wiring circuits

which could cause a fire hazard from

overheated wires. It is recommended

that a separate circuit serving only this

appliance be provided.

Unpacking Your Fridge

WARNING

Use two or more people to move and install

the fridge. Failure to do so can result in back

or other injury.

Your fridge is heavy. When moving the fridge

for cleaning or service, be sure to protect

the floor. Always pull the fridge straight

out when moving it. Do not wiggle or walk

the fridge when trying to move it, as floor

damage could occur. Wind the leveling feet

up first so that the unit is on its rollers.

Keep flammable materials and vapors, such

as gasoline, away from the fridge. Failure to

do so can result in fire, explosion, or death.

Remove tape and any temporary labels from your

fridge before using. Do not remove any warning-

type labels, the model and serial number label, or

the Tech Sheet that is located under the front of

the fridge.

To remove any remaining tape or glue, rub the

area briskly with your thumb. Tape or glue residue

can also be easily removed by rubbing a small

amount of liquid dish soap over the adhesive with

your fingers. Wipe with warm water and dry.

Do not use sharp instruments, rubbing alcohol,

flammable fluids, or abrasive cleaners to remove

tape or glue. These products can damage the

surface of your fridge.

Fridge shelves are installed in the shipping

position. Please reinstall shelves according to

your individual storage needs.

Flooring

To avoid noise and vibration, the unit must be

leveled and installed on a solidly constructed

floor. If required, adjust the leveling legs to

compensate for unevenness of the floor. The

front should be slightly higher than the rear to

aid in door closing. Leveling legs can be turned

easily by tipping the cabinet slightly. Turn the

leveling legs to the left to raise the unit or to

the right to lower it. Poorly constructed timber

flooring can cause a limit in door adjustment

and the cabinet to become out of shape. (See

Leveling and door Door Alignment.)

NOTE

Installing on carpeting, soft tile surfaces,

a platform or weakly supported structure

is not recommended.

NOTE

The water pressure must be 20 – 120 psi

or 138 – 827 kPa or 1.4 – 8.4 kgf/cm².

If the fridge is installed in an area with low

water pressure (below 20 psi), you can

install a booster pump to compensate for

the low pressure.

WARNING

To reduce the risk of electric shock, do not

install the fridge in a wet or damp area.

do not install in any outdoor or sheltered

outdoor location or direct sunlight.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

LG GMJ916NSHV Seite 10

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von LG GMJ916NSHV

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info