Bedienungsanleitung Liebherr BCv 1103 (Seite 10 von 40) (Deutsch, Englisch, Holländisch, Französisch, Italienisch, Spanisch)

726273

Zoom out

Zoom in

Vorherige Seite

1/40

Nächste Seite

Setting up

• Do not place the appliance in direct sunlight or near

cookers, radiators and similar sources of heat.

• The oor on which the appliance stands

should be horizontal and level.Compen-

sate for uneven oors with the adjust-

able feet.

• ATTENTION: There must be a gap of at least 10 cm

between the side enclosure (left and right) and rear

enclosure of the appliance against the wall.

• Always ensure there is good ventilation and that the

outward owing air is able to escape. Always install the

appliance directly against the wall.

• Do not cover ventilation openings or grille.

• Standard EN 378 species that the room in which you

install your appliance must have a volume of 1 m

per

8 g of R 600a / R 290 refrigerant used in the appli-

ance, so as to avoid the formation of inammable gas/air

mixtures in the room where the appliance is located in

the event of a leak in the refrigerant circuit. The quantity

of refrigerant used in your appliance is indicated on the

type plate on the inside of the appliance.

Electrical connection

Only operate the appliance with alternating current (AC).

The permissible voltage and frequency are indicated on

the type plate. The position of the type plate is shown in

the section entitled Description of the appliance.

The socket must be properly earthed and protected by a

fuse.

The tripping current of the fuse must be between 10 A and

16 A.

The socket must not be situated behind the

appliance and must be easily accessible.

Do not connect the appliance using an exten-

sion cable or extension socket.

Do not use stand-alone inverters (conver-

sion of direct current to alternating current / three phase

current) or energy-saving plugs. Risk of damage to the

electronic control system!

Switch the appliance on and o

You are recommended to clean the appliance before

switching it on for the rst time. The appliance is delivered

ready for use and wired for normal operation. When it is

connected up, the appliance is ready for operation.

To switch the appliance on

Connect the appliance to the mains - the appliance is

switched on.

To switch the appliance o

Pull out the mains plug - the appliance is switched o.

Important

When the temperature control is turned to “•“, the refrig-

eration system is switched o, but the appliance is not

completely disconnected from the mains.

Temperature display

The thermometer is located on the left of

inner compartment.

Setting the temperature

Using a coin, turn the arrow of the

temperature control T to a setting

between 1 and 7.

Setting 1 = highest temperature

Setting 7 = lowest temperature

Climate rating

The climate rating indicates the room temperature at which

the appliance maybe operated in order to achieve full refrig-

eration performance.

The climate rating is indicated on the type

plate.

The position of the type plate is shown

in the section entitled Description of the

appliance.

Climate rating Room temperature

0 20°C

3 25°C

4 30°C

7 35°C

Do not operate the appliance outside the

specied room temperature range.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Liebherr BCv 1103 Seite 10

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info