Bedienungsanleitung Liebherr CBNPes 5167 PremiumPlus (Seite 3 von 15) (Englisch)

597392

Zoom out

Zoom in

Vorherige Seite

1/15

Nächste Seite

Dimensions (mm)

Setting up

• Avoid positioning the appliance in direct sunlight or near cookers,

radiators and similar sources of heat.

• The floor on which the appliance stands should be horizontal and

level. To compensate for any unevenness, adjust the height of the

feet with the open-ended spanner supplied.

• The ventilation grilles should not be obstructed. Always ensure

that there is good ventilation and that the outward flowing air is

able to escape.

• Do not place heat-emitting appliances, e.g. microwave oven,

toaster, etc., on top of the appliance.

• Standard EN 378 specifies that the room in which you install your

appliance must have a volume of 1 m

per 8 g of R 600a refrigerant

used in the appliance, so as to avoid the formation of inflammable

gas/air mixtures in the room where the appliance is located in the

event of a leak in the refrigerant circuit. The quantity of refrigerant

used in your appliance is indicated on the type plate on the inside

of the appliance.

Safety instructions and warnings

• To prevent injury or damage to the unit, the appliance should be

unpacked and set up by two people.

• In the event that the appliance is damaged on delivery, contact

the supplier immediately before connecting to the mains.

• To guarantee safe operation, ensure that the appliance is set up

and connected as described in these operating instructions.

• Disconnect the appliance from the mains if any fault occurs. Pull

out the plug, switch off or remove the fuse.

• When disconnecting the appliance, pull on the plug, not on the

cable.

• Any repairs and work on the appliance should only be carried

out by the customer service department, as unauthor ised work

could prove highly dangerous for the user. The same applies to

changing the mains power cable.

• Do not allow naked flames or ignition sources to enter the appli-

ance. When transporting and cleaning the appliance ensure that

the refrigerant circuit is not damaged. In the event of damage,

make sure that there are no ignition sources nearby and keep the

room well ventilated.

• Do not stand on the plinth, drawers or doors or use them to sup-

port anything else.

• This appliance is not intended for use by persons (including chil-

dren) with reduced physical, sensory or mental capabilities or lack

of experience and knowledge unless they have been given initial

supervision or instruction concerning use of the appliance by a

person responsible for their safety. Children should be supervised

to ensure that they do not play with the appliance.

• Avoid prolonged skin contact with cold surfaces or chilled/frozen

food. This could cause pain, numbness and frostbite. In the case

of prolonged skin contact, protective measures should be taken,

e.g. gloves should be worn.

• Do not eat ice cream, particulary ice lollies or ice cubes, imme-

diately after taking them from the freezer compartment as there

is a risk of "burning" because of the very cold temperatures.

• Do not consume food which has been stored for too long, as it

could cause food poisoning.

• The appliance is designed for cooling, freezing and storage of

food, and for making ice and is intended for domestic use. If used

for commercial purposes, the relevant legal regulations applicable

to the trade concerned must be observed.

• Do not store explosives or sprays using combustible propellants

such as butane, propane, pentane etc. in the appliance. Electrical

components might cause leaking gas to ignite. You may identify

such sprays by the printed contents or a flame symbol.

• Do not use electrical appliances inside the appliance.

• The appliance is designed for use in enclosed areas. Do not

operate the appliance outdoors or in areas where it is exposed

to splash water or damp conditions.

• Special-purpose lamps (incandescent lamps, LEDs, fluorescent

tubes) in the appliance serve to illuminate the appliance interior

and are not suited for room illumination.

Electrical connection

Only operate the appliance with alternating current (AC).

The permissible voltage and frequency are indicated on the type

plate. The position of the type plate is shown in the description of

the appliance.

The socket must be properly earthed and protected by a fuse.

The tripping current of the fuse must be between 10 A and 16 A.

The socket must not be situated behind the appliance and must

be easily accessible.

Do not connect the appliance using an exten-

sion cable or extension socket.

Do not use stand-alone inverters (conversion

of direct current to alternating/three-phase cur-

rent) or energy-saving plugs. Risk of damage

to the electronic control system!

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Liebherr CBNPes 5167 PremiumPlus Seite 3

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Liebherr CBNPes 5167 PremiumPlus

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info