13
Power failure display
If nA appears in the display and alarm sounds,
this means that the freezer temperature has
risen too high during the last few hours or
days due to a power failure.
To disable nA display and alarm, press the
ALARM button. The alarm will stop immedi-
ately and the highest registered temperature during power failure
will be displayed. This temperature will be display in approximately
1 minute. To cancel immediately this highest temperature display,
press again the ALARM button and the display will show the actual
temperature of the appliance.
Check the quality of the packed food and its suitability for consump-
tion in case it has become too warm or even defrosted.
Audible warning signal
The audible warning device helps to protect the frozen packed
food and to save energy.
- It sounds when the lid has been left open for longer than about
60 seconds.
- It sounds when it is not cold enough in the
freezer compartment. The temperature dis-
play will also flash.
The audible warning device is switched off by
pressing the ALARM button.
Switching the appliance on and off
You are recommended to clean the appliance before switching it
on for the first time (see Cleaning).
To switch the appliance on: Press the ON/OFF button until the
temperature display lights up.
- The two illuminated dashes of the digital
temperature display will light up until a
temperature of 0°C is reached.
- If the temperature is below 0°C, the digital
temperature display will show the tempera-
ture inside the appliance.
- The appliance needs to stay ON for 6 hours before the user can
load the frozen foods.
To switch the appliance off: Press the ON / OFF button for ap-
prox. 3 seconds so that the temperature display goes out.
Setting the temperature
• To reduce the temperature: Press the
bottom button Down.
• To increase the temperature: Press the
top button Up.
- While you are entering the temperature, the
set temperature will flash on the display.
- You can change the settings in increments
of 1°C briefly pressing the button again. If the buttons are held
down the temperature setting will change faster.
- The electronic controls will switch over automatically about
5 seconds after the last time you pressed the button, and the
actual temperature in the freezer will be displayed.
ΠOn/O! button
• SuperFrost button
Ž Audible warning on/o! button
• Child lock LED
• SuperFrost LED
‘ Temperature display
’ Temperature setting buttons
Operating and control elements
Electrical connection
Only operate the appliance with alternating current (AC).
The permissible voltage and frequency are indicated on the type
plate. The position of the type plate is shown in the section entitled
Description of the appliance.
The socket must be properly earthed and protected by a fuse.
The tripping current of the fuse must be between 10 A and 16 A.
The socket must not be situated behind the appli-
ance and must be easily accessible.
Do not connect the appliance using an extension cable or exten-
sion socket.
Do not use stand-alone inverters (conversion
of direct current to alternating current/three-
phase current) or energy-saving plugs. Risk
of damage to the electronic control system!
Saving energy
- Always ensure good ventilation. Do not cover ventilation open-
ings or grille.
- Avoid positioning the appliance in direct sunlight or near cook-
ers, radiators and similar sources of heat.
- The energy consumption depends on the installation conditions,
e.g. the ambient temperature.
- Keep the time the appliance is open to a minimum.
- Store packed foods logically.
- Keep all food properly packed and covered so as to avoid its
frosting up on the outside.
- Always allow hot food to cool to room temperature before packed
placing in the appliance.
- If there is a thick layer of frost in the appliance: defrost the ap-
pliance.
Accumulated dust increases the energy consumption:
- Regularly clean the motor compartment ventilation openings to
keep them free from dust.
EN
