Bedienungsanleitung Liebherr ECBN 6256 (Seite 7 von 18) (Englisch)

715463

Zoom out

Zoom in

Vorherige Seite

1/18

Nächste Seite

Power failure/FrostControl display

If the LED comes on on the control panel, this means that the

freezer temperature has risen too high during the last few hours

or days due to a power failure.

If you touch the ALARM icon now, the highest temperature

registered during the power failure will be displayed.

Check the quality of the food and its suitability for consumption

in case it has become too warm or even defrosted.

The highest temperature will appear for appox. 1 minute. After

that, the actual temperature in the freezer will re-appear.

The display can be switched off by touching the ALARM icon.

Audible warning signal

The appliance is equipped with an alarm function.

Audible door alarm

If an appliance door is left open for more than 60 seconds,

the audible warning signal will sound. Touch the ALARM

icon to cancel the alarm. The alarm switches back to

standby when the door is shut.

Audible/visual temperature alarm

It sounds when it is not cold enough in the freezer compartment.

The temperature display and the LED will also flash.

The audible warning device is switched off by touching

the ALARM icon. The temperature display will continue

to flash until the cause of the alarm has been rectified.

This can be caused by:

• the freezer door being left open for a long time, allowing warm

ambient air to enter;

• a long power failure;

• a fault in the appliance.

In each case, make sure food has not thawed or perished.

SuperCool

Touching the SuperCool icon switches the refrigerator compart-

ment to maximum cooling. It is recommended particularly if you

wish to cool large quantities of food, drinks, freshly baked goods

or meals rapidly.

Switching on: Touch the SuperCool icon briefly so that

the LED comes on. The refrigerator temperature will

drop to its lowest value.

Note: The SuperCool function uses slightly more energy. After

approximately six hours, however, the refrigerator switches back

automatically to normal energy-saving operation. If required, the

SuperCool function can be switched off sooner.

Switching off: Touch the SuperCool icon again until the LED

goes out.

Setup mode

The following functions can be activated in setup mode:

= Sabbath mode

= Child lock

= Confirm water filter change

= Ice maker vacation state

= Water quantity for ice cube tray

= Set BioFresh temperature

= Display brightness

= Door gasket heating control

=Confirm dust filter cleaning

Activating setup mode

• Touch the SuperFrost icon for five seconds.

- The SuperFrost LED comes on for 5 seconds,

- after 5 seconds will flash in the display.

The appliance is in setup mode now.

You can select the setup mode functions by touching

the freezer compartment temperature setting icons.

Note

In setup mode the display will flash continuously.

Exiting setup mode

• Touch the freezer compartment On/Off icon

The appliance will change back to normal operation.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Liebherr ECBN 6256 Seite 7

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Liebherr ECBN 6256

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info