Bedienungsanleitung Liebherr EWTgw 3583 (Seite 5 von 12) (Englisch)

710976

Zoom out

Zoom in

Vorherige Seite

1/12

Nächste Seite

Setting up

• Avoid positioning the appliance in direct sunlight or near cookers,

radiators and similar sources of heat.

• Standard EN 378 specifies that the room in which you install

your appliance must have a volume of 1 m3 per 8 g of R 600a

refrigerant used in the appliance, so as to avoid the formation of

inflammable gas/air mixtures in the room where the appliance is

located in the event of a leak in the refrigerant circuit. The quantity

of refrigerant used in your appliance is indicated on the type plate

on the inside of the appliance.

Electrical connection

Only operate the appliance with alternating current (AC).

The permissible voltage and frequency are indicated on the type

plate. The position of the type plate is shown in the section entitled

Description of the appliance.

The socket must be properly earthed and protected by a fuse.

The tripping current of the fuse must be between 10 A and 16 A.

The socket must not be situated behind the appli-

ance and must be easily accessible.

Do not connect the appliance using an exten-

sion cable or extension socket.

Do not use stand-alone inverters (conversion

of direct current to alternating/three-phase

current) or energy-saving plugs. Risk of dam-

age to the electronic control system!

Climate rating

The climate rating indicates the room

temperature at which the appliance may

be operated in order to achieve full refrig-

eration performance.

The climate rating is indicated on the

type plate.

The position of the type plate is shown in the section entitled

Description of the appliance.

Climate rating Room temperature

SN +10°C to +32°C

N +16°C to +32°C

ST +16°C to +38°C

T +16°C to +43°C

SN-ST +10°C to +38°C

SN-T +10°C to +43°C

Do not operate the appliance outside the

specied room temperature range.

Door opening mechanism

The appliance is equipped with a

door opening mechanism.

Opening the door

Push the door slightly inwards on

the top left-hand side and release

again.

The door is opened approx.

7 cm by the push rod.

The door can then be fully

opened.

Note

The door will close again

automatically after approx.

3 seconds if it has not been

fully opened.

Do not push the push rod in or hold on to it during

closing.

If the push rod is blocked during

closing, it will no longer be able to

reach its initial position.

In the initial position, the push rod is

ush with the front of the appliance.

Setting the push rod back in its initial position

Disconnect the appliance from the mains, wait for approx.

5 seconds and plug it back in again.

The push rod returns to its initial position.

Important notes

Do not operate the appliance near magnetic elds or

place magnetic objects near the appliance.

The door may otherwise open when you do not want

it to.

Do not block the door or hold on to it while it is

opening.

If the door is blocked or held open during opening, the internal

safety coupling will be activated.

Loud, repeated cracking noises will be heard.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Liebherr EWTgw 3583 Seite 5

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Liebherr EWTgw 3583

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info