Bedienungsanleitung Liebherr FNc 4675 (Seite 25 von 28) (Englisch)

802967

Zoom out

Zoom in

Vorherige Seite

1/28

Nächste Seite

Defect Cause Remedy

→The appliance was opened too

many times or for too long.

uWait to see if the required temperature corrects itself.

If not, contact Customer Service (see 9.4 Customer Serv‐

ices) .

→Too much fresh food was placed

inside without SuperFrost.

uSolution: (see SuperFrost)

→ The temperature is set incorrectly. uTurn down the temperature and check after 24 hours.

→The appliance is too close to a heat

source (oven, radiator, etc).

uMove the appliance or the heat source.

The status display

does not light up.*

→ The status display is switched off. uTurn on the status display (see Status light (status

display)*) .

→ The door is open. uClose the door.

→ The appliance is switched off. uSwitch the appliance on.

→ LED is faulty. uContact Customer Services (see 8 Maintenance) .

The door seal is

defective or needs

to be replaced for

another reason.

→The door seal can be replaced. It

can be replaced without the need

for special tools.

uContact Customer Services (see 9.4 Customer Services) .

The appliance

builds up too much

ice or condensa‐

tion.

→The door seal may have slipped out

of its groove.

uCheck that the door seal is well fitted in the groove.

The appliance is

hot to touch on the

outside*.

→The heat of the refrigeration circuit

is used to avoid condensation.

uThis is normal.

9.3.2 Features

Defect Cause Remedy

You cannot acti‐

vate the IceMaker.*

→The appliance and therefore the

IceMaker are not connected.

uConnect the appliance (see the Installation Guide).

The IceMaker is

not producing ice

cubes.*

→ The IceMaker is not on. uActivate the IceMaker.

→The drawer of the IceMakers is not

connected properly.

uPush the drawer in correctly.

→ The water connection is not open. uOpen the water connection.*

The internal light

does not come on.

→ The appliance is not switched on. uSwitch the appliance on.

→The door was open for longer than

15 minutes.

uInterior lighting turns off automatically after approx. 15

min. with the door open.

→The LED interior light is faulty or

the lid is damaged.

uContact customer service (see 9.4 Customer Services) .

9.4 Customer Services

First check if you can fix the error yourself (see 9 Customer

help) . If you can't, contact Customer Services.

Please refer to the enclosed “Liebherr-Service” brochure for

the address.

WARNING

Unprofessional repair!

Injuries.

uHave any repairs and action - not expressly specified -

on the appliance and mains cable carried out by service

personnel only. (see 8 Maintenance)

uA damaged mains cable may only be replaced by the

manufacturer, the manufacturer’s Customer Service or a

similarly qualified person.

uIn the case of appliances with an IEC connector, the

change may be made by the customer.

Customer help

* Depending on model and options 25

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Liebherr FNc 4675 Seite 25

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Liebherr FNc 4675

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info