Bedienungsanleitung Liebherr GN1066 (Seite 11 von 14) (Englisch)

805276

Zoom out

Zoom in

Vorherige Seite

1/14

Nächste Seite

A bubbling and gurgling noise.

→This noise comes from the refrigerant flowing in the

refrigeration circuit.

uThe sound is normal.

A quiet clicking noise.

→The noise is produced whenever the refrigeration unit

(motor) automatically switches on or off.

uThe sound is normal.

A hum. It is briefly a little louder when the refrigeration

unit (the motor) switches on.

→The refrigeration increases automatically when the

SuperFrost, function is activated, fresh food has just

been placed in the appliance or the door has been left

open for a while.

uThe sound is normal.

→The ambient temperature is too high.

uSolution: (see 1.2 Appliance range of use)

Vibration noises

→The appliance is not standing firmly on the floor. As a

result objects and adjacent units start to vibrate when

the refrigerator is running.

uAlign the appliance using the adjustable feet.

The temperature display indicates: F0 to F5.

→There is a fault.

uPlease contact the after-sales service (see 6 Mainte‐

nance) .

Power failure flashes in the temperature display . The

highest temperature reached during power failure is indi‐

cated in the temperature display.

→The freezer temperature rose too high over the last

hours or days due to a power failure or power interrup‐

tion. When the power interruption is over, the appliance

will continue to operate in the last temperature setting.

uTo cancel the display of the warmest temperature: press

alarm button Fig. 3 (9).

uCheck the quality of the food. Do not consume spoiled

food. Do not re-freeze thawed food.

DEMO shines in the temperature display.

→The demo mode is activated.

uPlease contact the after-sales service (see 6 Mainte‐

nance) .

The outer surfaces of the appliance are warm*.

→The heat of the refrigeration circuit is used to prevent

condensate from forming.

uThis is normal.

The temperature is not cold enough.

→The door of the appliance is not properly closed.

uClose the door of the appliance.

→Insufficient ventilation.

uKeep ventilation grille clear, and clean it.

→The ambient temperature is too high.

uSolution: (see 1.2 Appliance range of use) .

→The appliance was opened too frequently or for too long.

uWait to see whether the appliance reaches the required

temperature by itself. If not, please contact the after

sales service (see 6 Maintenance) .

→Too much fresh food was placed inside without

SuperFrost.

uSolution: (see 5.8 SuperFrost)

→The temperature is incorrectly set.

uSet the temperature to a colder setting and check after

24 hours.

→The appliance is too close to a source of heat (stove,

heater etc).

uChange the position of the appliance or the source of

heat.

Dashes (“- -”) are shown on the display.

→The freezing temperature has risen above zero degrees

because of a power cut or power interruption.

uSee also "Power failure" and " "

8 Decommissioning

8.1 Switching off the appliance

uPress the On/Off button Fig. 3 (1) until the display goes

dark. Release button.

wIf the appliance cannot be switched off, the child lock

function is active (see 5.2 Child proofing) .

8.2 Taking the appliance out of service

uEmpty the appliance.

uSwitch off the appliance (see 8 Decommissioning) .

uRemove mains connector.

uClean the appliance (see 6.2 Cleaning the appli‐

ance) .

uLeave the door open to prevent odour.

9 Disposal

9.1 Preparing appliance for disposal

Liebherr uses batteries in some of its appli‐

ances. In the EU, for environmental reasons,

legislation obliges the end user to remove

these batteries before disposing of old appli‐

ances. If your appliance contains batteries, a

corresponding notice is attached.

Lamps If you can remove the lamps yourself without

destroying them, also remove these before

disposal.

uTake the appliance out of operation. (see 8.2 Taking the

appliance out of service)

uAppliances with batteries: remove the batteries. For

description, see Maintenance chapter.

uIf possible: remove lamps without destroying them.

9.2 Disposing of the appliance in an

environmentally friendly manner

The appliance still contains

valuable materials and must

be disposed of separately from

unsorted municipal waste.

Dispose of batteries separately

from the old appliance. To do

this, you can return the batteries

free of charge to retailers as

well as recycling centres and

collection centres for recyclable

materials.

Lamps Dispose of removed lamps

via the respective collection

systems.

Decommissioning

* Depending on model and options 11

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Liebherr GN1066 Seite 11

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Liebherr GN1066

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info