Bedienungsanleitung Liebherr GP1213 (Seite 12 von 14) (Englisch)

805279

Zoom out

Zoom in

Vorherige Seite

1/14

Nächste Seite

Defect Cause Remedy

when the refrig‐

eration unit (the

motor) switches

on.

has just been placed in the appli‐

ance or the door has been left open

for a while.

→The ambient temperature is too

high.

uSolution: (see1.2 Appliance range of use)

Vibration noises →The appliance is not standing

firmly on the floor. As a result

objects and adjacent units start

to vibrate when the refrigerator is

running.

uAlign the appliance using the adjustable feet.

The SuperFrost

symbol Fig.3(5)

flashes together

with the tempera‐

ture display.

→ There is a fault. uPlease contact the after-sales service (see 6 Mainte‐

nance) .

DEMO shines in

the temperature

display.

→ The demo mode is activated. uPlease contact the after-sales service (see 6 Mainte‐

nance) .

The outer surfaces

of the appliance

are warm*.

→The heat of the refrigeration circuit

is used to prevent condensate from

forming.

uThis is normal.

The temperature is

not cold enough.

→The door of the appliance is not

properly closed.

uClose the door of the appliance.

→ Insufficient ventilation. uKeep ventilation grille clear, and clean it.

→The ambient temperature is too

high.

uSolution: (see1.2 Appliance range of use) .

→The appliance was opened too

frequently or for too long.

uWait to see whether the appliance reaches the required

temperature by itself. If not, please contact the after

sales service (see6 Maintenance) .

→Too much fresh food was placed

inside without SuperFrost.

uSolution: (see 5.8SuperFrost)

→ The temperature is incorrectly set. uSet the temperature to a colder setting and check after

24 hours.

→The appliance is too close to a

source of heat (stove, heater etc).

uChange the position of the appliance or the source of

heat.

Concentrated

collection of ice

on inside face at

centre of appliance

cover.

→This build-up of ice is normal. Due

to physical properties, ice concen‐

trates inside the top of the appli‐

ance.

uRemove the ice with a scraper tool.

8 Decommissioning

8.1 Switching off the appliance

uPress the On/Off button Fig. 3 (1) until the display goes

dark. Release button.

wIf the appliance cannot be switched off, the child lock

function is active (see 5.2 Child proofing) .

8.2 Taking the appliance out of service

uEmpty the appliance.

uSwitch off the appliance (see8Decommissioning) .

uRemove mains connector.

uClean the appliance (see6.2 Cleaning the appli‐

ance) .

uLeave the door open to prevent odour.

9 Disposal

9.1 Preparing appliance for disposal

Liebherr uses batteries in some of its appli‐

ances. In the EU, for environmental reasons,

legislation obliges the end user to remove

these batteries before disposing of old appli‐

ances. If your appliance contains batteries, a

corresponding notice is attached.

Lamps If you can remove the lamps yourself without

destroying them, also remove these before

disposal.

Decommissioning

12 * Depending on model and options

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Liebherr GP1213 Seite 12

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Liebherr GP1213

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info