Bedienungsanleitung Liebherr IRBd 4551 (Seite 26 von 28) (Englisch)

805339

Zoom out

Zoom in

Vorherige Seite

1/28

Nächste Seite

Defect Cause Remedy

be replaced for

other reasons.

The appliance is

iced up or conden‐

sation is building.

→The door seal may have slipped out

of its groove.

uCheck the door seal is well placed in the groove.

9.3.2 Equipment

Defect Cause Remedy

The InfinitySpring

is not working.*

→ There is air in the system. uVent the water system (see Installation Instructions,

Water Connection).

→ The water connection is not open uOpen the water connection*

The water flow at

the InfinitySpring

is irregular.*

→ The aerator is not clean. uReplace the aerator. Contact Customer Service

(see 9.4 Customer service) .

HydroBreeze is not

keeping refriger‐

ated foods moist.*

→ HydroBreeze is not activated. uActivate the HydroBreeze.

→There is not enough water in the

water tank

uFill the water tank.

→There is dirt upstream of the

concentrator.

uClean the HydroBreeze.

→The water tank is not properly

locked into place.

uMake sure the water tank clicks in properly.

→The lid of the Fruit & Vegetable-

Safe is set to “low air moisture”.

uAdjust the lid of the Fruit & Vegetable-Safe to “high air

moisture”.

The interior light

does not turn on.

→ The appliance is not switched on. uSwitch on the appliance.

→The door was open for longer than

15 min.

uThe interior light automatically switches itself off if the

door stays open for approx. 15 min.

→The LED interior light is faulty or

the lid is damaged.

uContact Customer Service (see 9.4 Customer service) .

The freezer door

will not shut.*

→The catch is locked with the door

open.

uTry the handle again.

9.4 Customer service

First check if you can fix the error yourself (see 9 Customer

support) . If this is not the case, please contact customer

service.

Please refer to the enclosed “Liebherr Service” brochure for

the address.

WARNING

Unprofessional repair!

Injuries.

uRepairs and work on the appliance and the power supply

cable not described in the Manual (see 8 Maintenance)

should only be carried out by a qualified service provider.

uA damaged power cable may only be replaced by the

manufacturer, the manufacturer’s Customer Service or a

similarly qualified person.

uFor appliances with an IEC connector, the change can be

made by the customer.

9.4.1 Contact Customer Service

Make sure to have the following appliance information to

hand:

qAppliance name (model and index)

qService no. (service)

qSerial no. (S no.)

uShowing appliance info on the display (see Info) .

-or-

uReferring to appliance info on the nameplate

(see 9.5 Rating plate) .

uTake note of the appliance information.

uInform Customer Service: Tell us the problem and the

appliance details.

wThis will help us give you fast and accurate support.

uFurther instructions from customer service will follow.

9.5 Rating plate

The nameplate is located behind the drawers on the inside

of the appliance.

Customer support

26 * Depending on model and options

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Liebherr IRBd 4551 Seite 26

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Liebherr IRBd 4551

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info