Bedienungsanleitung Liebherr TP 1434 (Seite 8 von 14) (Englisch)

597433

Zoom out

Zoom in

Vorherige Seite

1/14

Nächste Seite

4.7 Connecting the appliance

NOTICE

Failure to connect properly

Damage to the electronics.

uDo not connect the appliance to a stand-alone inverter, e.g.

solar power systems and petrol generators.

uDo not use an energy saving plug.

WARNING

Failure to connect properly

Fire hazard.

uDo not use an extension cable.

uDo not use distributor blocks.

The type of current (alternating current) and voltage at the

installation site have to conform with the data on the type plate

(see 1 Appliance at a glance) .

The socket must be properly earthed and fused. The tripping

current for the fuse must be between 10 A and 16 A.

The socket must be easily accessible so that the appliance can

be quickly disconnected from the supply in an emergency. It

must be outside the area of the rear of the appliance.

uCheck the electrical connection.

uPlug in the power plug.

4.8 Switching on the appliance

Put the appliance into operation about 2 hours before first

loading food to be frozen.*

uTurn the temperature control

Fig. 3 (1)

to the right, from the 0

setting to point 3.

wThe interior light is on.

5 Control

5.1 Refrigerator compartment

The natural circulation of air in the refrigerator compartment

results in zones differing in temperature. It is coldest directly

above the vegetable drawers and at the rear wall. It is warmest

at the top front of the compartment and in the door.

5.1.1 Refrigerating food

The coldest areas are directly above the vegetable compart-

ments and along the back wall. The warmest area is at the top

front and in the door.*

uStore perishable foods such as ready-to-eat meals, meat

and sausages in the coldest area. Place butter and

preserves in the top area and in the door. (see 1 Appliance

at a glance)

uUse reuseable plastic, metal, aluminium, glass containers

and foil wrap to store food.

uAlways store raw meat and fish in clean, sealed containers

on the bottom shelf of the refrigerator, to prevent them

coming into contact with or dripping onto other foods.

uFoods that easily absorb or give off smell or taste, as well as

liquids, should be stored in sealed containers or covered.

uDo not pack foods too closely together, as the air needs to

circulate.

5.1.2 Setting the temperature

The temperature can be set between 1 (warmest temperature,

minimum cooling performance) and 7 (coldest temperature,

maximum cooling performance).

The middle control setting is recommended, then a middle

temperature of approx.5 °C is established in the refrigerator

compartment.

An average temperature of approx. –18 °C is then established

in the freezer compartment.*

To ensure ideal temperatures for storing frozen foods, a setting

of “4” to “7” on the temperature controller is recommended.

Selecting “7” makes it possible to achieve temperatures under

0 °C in the coldest part of the fridge compartment.*

uTurn the temperature control

Fig. 3 (1)

The temperature depends on the following factors:

- the door opening frequency

- how long the door is open for

- the room temperature at the site where the appliance is

installed

- the type, temperature and quantity of frozen food

uAdjust the temperature as needed, using the control.

5.1.3 CoolPlus function*

At low room temperatures of 15 °C or lower:

uPress the Cool-Plus switch

Fig. 3 (2)

wThe deep temperatures in the freezer compartment are

ensured.

Once the room temperature is again higher than 15 °C :

uDeactivate the Cool-Plus

Fig. 3 (2)

switch manually.

Note

uAt normal room temperatures, in excess of 15 °C, the Cool-

Plus switch should be turned off, as it is not required.

5.1.4 Shelves

Moving or removing shelves

The shelves are prevented from being pulled out accidentally

by pull out stops.

Fig. 11

uLift the shelf and pull forward a little.

uAdjust the height of the shelf. To do this move the slots along

the supports.

uIn order to remove the shelf fully, place it at a slant and pull

out towards the front.

uInsert shelf with the raised edge pointing upwards at the

back.

wThe food does not freeze onto the rear wall.

Dismantling shelves

uThe shelves can be

dismantled for cleaning.

Control

8 * Depending on model and options

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Liebherr TP 1434 Seite 8

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Liebherr TP 1434

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info