Bedienungsanleitung Liebherr TP1764 (Seite 8 von 14) (Englisch)

495721

Zoom out

Zoom in

Vorherige Seite

1/14

Nächste Seite

c flashes on the display.

The child lock function is switched off.

If setting mode is to be terminated:

Briefly press the On/Off button

Fig. 3 (1)

-or-

Wait for 5 minutes.

The temperature display shows the temperature again.

5.3 Refrigerator compartment

The natural circulation of air in the refrigerator compartment

results in zones differing in temperature. It is coldest directly

above the vegetable drawers and at the rear wall. It is warmest

at the top front of the compartment and in the door.

5.3.1 Refrigerating food

The coldest areas are directly above the vegetable compart-

ments and along the back wall. The warmest area is at the top

front and in the door.*

Store perishable foods such as ready-to-eat meals, meat

and sausages in the coldest area. Place butter and

preserves in the top area and in the door. (see 1 Appliance

at a glance)

Use reuseable plastic, metal, aluminium, glass containers

and foil wrap to store food.

Always store raw meat and fish in clean, sealed containers

on the bottom shelf of the refrigerator, to prevent them

coming into contact with or dripping onto other foods.

Foods that easily absorb or give off smell or taste, as well as

liquids, should be stored in sealed containers or covered.

Do not pack foods too closely together, as the air needs to

circulate.

5.3.2 Setting the temperature

The temperature depends on the following factors:

the frequency of opening the door

how long the door is open for

the room temperature of the installation location

the type, temperature and quantity of the food

Recommended temperature setting: 5 °C

An average temperature of approx. -18 °C is then established

in the freezer compartment.*

The temperature is changed sequentially. Once the 2 °C setting

is reached, the sequence starts again at 9 °C.

Call up temperature function: press the setting

button

Fig. 3 (2)

The previously-set value will flash in the temper-

ature display.

Change the temperature in 1 °C steps: Press the

setting button

Fig. 3 (2)

until the required

temperature is indicated in the temperature

display.

Change temperature continually: hold down

setting button.

During adjustment the value flashes on the

display.

The new setting is adopted approx. 5 seconds after the last

time the button was pressed and the set temperature is

again displayed. The temperature in the interior gradually

adjusts to the new value.

5.3.3 SuperCool*

With SuperCool you switch to the highest cooling

performance to reach lower cooling temperatures.

Use SuperCool, to rapidly cool large amounts of

food.

When SuperCool is activated, the appliance operates with

maximum cooling performance. The noise of the refrigeration

unit may be temporarily louder as a result.

The SuperCool function uses slightly more energy.

Cooling with SuperCool*

Briefly press SuperCool button

Fig. 3 (4)

The SuperCool symbol

Fig. 3 (9)

lights up in the display.

The cooling temperature drops to the coldest value.

SuperCool is activated.

SuperCool is automatically deactivated after 6 to12 hours

The appliance continues to operate in the energy-saving,

normal mode.

To prematurely deactivate SuperCool*

Briefly press SuperCool button

Fig. 3 (4)

The SuperCool symbol

Fig. 3 (9)

goes out in the display.

SuperCool is deactivated.

5.3.4 Shelves

Moving or removing shelves

The shelves are prevented from being pulled out accidentally

by pull out stops.

Fig. 9

Lift the shelf and pull forward a little.

Adjust the height of the shelf. To do this move the slots along

the supports.

In order to remove the shelf fully, place it at a slant and pull

out towards the front.

Insert shelf with the raised edge pointing upwards at the

back.

The food does not freeze onto the rear wall.

Dismantling shelves

The shelves can be

dismantled for cleaning.

5.3.5 Using the sectioned shelf

Fig. 10

Adjusting the height:

Pull the glass plates out forwards one by one.

Remove the support from the catch mechanism and click

into place at the required height.

Using both shelves:

Lift the top glass plate and pull the bottom glass plate

forwards.

The glass plate (1) with the pull out stops must be at the

front so that the stops (3) point downward.

Control

8 * Depending on model and options

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Liebherr TP1764 Seite 8

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Liebherr TP1764

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info