Bedienungsanleitung Liebherr XRFsf 5245 (Seite 47 von 50) (Englisch)

805299

Zoom out

Zoom in

Vorherige Seite

1/50

Nächste Seite

Defect Cause Remedy

→The powerfuse in the wall socket is

not OK.

uCheck the fuse.

→ Power failure. uKeep the appliance closed.

uProtect your food: Lay freezer packs on top of the food or

use another freezer if the power is off for a prolonged

period.

uDo not re-freeze defrosted food.

→The appliance connector is not

correctly inserted in the appliance.

uCheck the appliance connector.

The temperature is

not cold enough

→This means that the door of the

appliance is not closed properly

uClose the appliance door

→ Insufficient ventilation uClear and clean the ventilation grille.

→The ambient temperature is too

high

uSolution: (see 1.4 Range of appliance use) .

→The appliance was opened too

frequently or for too long

uWait to see whether the required temperature resets

itself by itself. If not, contact Customer Service

(see 9.4 Customer service) .

→ The temperature is incorrectly set uSet to a colder temperature and check after 24 hours.

→The appliance is too near to a heat

source (stove, heater etc).

uChange location of appliance or the heat source.

The door seal is

defective or should

be replaced for

other reasons.

→The door seal is interchangeable.

You can replace it without the use

of any special tools.

uContact Customer Service (see 9.4 Customer service) .

The appliance is

iced up or conden‐

sation is building.

→The door seal may have slipped out

of its groove.

uCheck the door seal is well placed in the groove.

The outside

surfaces of the

appliance are hot*.

→ The heat of the refrigerant circuit is

used to prevent condensate from

forming

uThis is normal.

9.3.2 Equipment

Defect Cause Remedy

The interior light

does not turn on.

→ The appliance is not switched on. uSwitch on the appliance.

→The door was open for longer than

15 min.

uThe interior light automatically switches itself off if the

door stays open for approx. 15 min.

→The LED interior light is faulty or

the lid is damaged.

uContact Customer Service (see 9.4 Customer service) .

The freezer door

will not shut.*

→The catch is locked with the door

open.

uTry the handle again.

9.4 Customer service

First check if you can fix the error yourself (see 9 Customer

support) . If this is not the case, please contact customer

service.

Please refer to the enclosed “Liebherr Service” brochure for

the address.

WARNING

Unprofessional repair!

Injuries.

uRepairs and work on the appliance and the power supply

cable not described in the Manual (see 8 Maintenance)

should only be carried out by a qualified service provider.

uA damaged power cable may only be replaced by the

manufacturer, the manufacturer’s Customer Service or a

similarly qualified person.

uFor appliances with an IEC connector, the change can be

made by the customer.

Customer support

* Depending on model and options 21

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Liebherr XRFsf 5245 Seite 47

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Liebherr XRFsf 5245

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info