13
C
ENTERING THE BELT
After installing and levelling the treadmill, check the belt to ensure that it is tracking properly. First,
plug the power cord into an appropriate outlet. See Electrical Power Requirements at the beginning
of this section for details. Then, turn the treadmill ON.
Have one person stand on the platforms on either side of the treadmill frame. Do not stand on the
belt at this time. Press the QUICK START key, and increase the speed to 4.0 miles per hour (MPH),
or 6.4 kilometers per hour (KPH), using the SPEED UP arrow.
If the striding belt moves to the right while it is running, have a second person turn the right tension
bolt a quarter-turn clockwise, and then turn the left tension bolt (A) a quarter-turn counter-clockwise.
See the illustration below. This action sets the striding belt tracking back to center of the roller.
If the striding belt moves to the left, turn the left tension bolt a quarter-turn clockwise and then turn
the right tension bolt a quarter-turn counter-clockwise to start the striding belt tracking back to center
of roller.
Repeat these adjustments until striding belt appears centered. Allow the belt to continue running for
several minutes to be sure that the tracking is stabilized.
NOTE: Do not exceed one full turn of the adjusting screws in either direction. If, after one full turn,
the belt does not track properly, contact Customer Support Services. The phone numbers are listed in
Section 6.7, titled How to Obtain Product Service.
S
TRIDE SENSOR AUTO-SHUTOFF SYSTEM
The Stride Sensor auto-shutoff system detects whether a user is on the belt/deck. If the user
leaves the belt/deck during a workout, the system is triggered and the following message is dis-
played, "User not detected on belt - press “OK” to continue workout." If the user presses “OK”
during this message the workout will continue without interruption. If the user does not press
“OK” another message will be displayed, "User not detected on belt; RESUME WORKOUT /
EXIT WORKOUT". At this point power to the belt will shut off as the treadmill enters Pause
mode. If the user presses RESUME WORKOUT during the second message the workout will be
resumed. If the user does not press RESUME WORKOUT, the treadmill will continue in Pause
mode and eventually end the workout. This feature can be disabled in the Manager's
Configuration.
